New insights into the use of multi-mode phenomenological constitutive equations to model extrusion film casting process
| Title | New insights into the use of multi-mode phenomenological constitutive equations to model extrusion film casting process |
| Publication Type | Journal Article |
| Year of Publication | 2017 |
| Authors | Thete, SS, Doshi, P, Pol, HV |
| Journal | Journal of Plastic Film & Sheeting |
| Volume | 33 |
| Issue | 1 |
| Pagination | 35-71 |
| Date Published | JAN |
| Abstract | This article is concerned with the effect of the individual viscoelastic relaxation modes of a polymer melt on its behavior in polymer melt extrusion film casting process. We compare the predicted versus experimentally obtained film necking or neck-in profile as a function of draw ratio. The predicted necking profile was obtained using well-established one-dimensional isothermal flow kinematics and consisted of using two different phenomenological constitutive equations, upper convected Maxwell and Phan-Thien-Tanner, with a discrete spectrum of relaxation times. The numerical simulations, containing the two different phenomenological constitutive equations, provided an insight into the effect of the slow and the fast relaxing modes on the stresses, strains, and strain/extensional rates that develop in the molten polymer film as it is stretched from the die exit to the chill-roll. The slow relaxing modes follow trends that are directly proportional to strain (similar to Hookean solids), whereas the fast relaxing modes follow trends that are directly proportional to the stretch rate (in accordance with Newton's law of viscosity). Comparing the numerical predictions with the experiments showed that predictions using the upper convected Maxwell constitutive equation best described the long-chain branched polymers (like low-density polyethylene, which shows extensional strain hardening) in the extrusion film casting process. On the other hand, predictions using the Phan-Thien-Tanner constitutive equation best described the linear polymers (like linear low-density polyethylene, which does not show noticeable extensional strain hardening) in the extrusion film casting process. |
| DOI | 10.1177/8756087915627843 |
| Type of Journal (Indian or Foreign) | Foreign |
| Impact Factor (IF) | 0.00 |
Divison category:
Polymer Science & Engineering