<?xml version="1.0" encoding="UTF-8"?><xml><records><record><source-app name="Biblio" version="7.x">Drupal-Biblio</source-app><ref-type>17</ref-type><contributors><authors><author><style face="normal" font="default" size="100%">Unni, SreeKuttan M.</style></author><author><style face="normal" font="default" size="100%">Illathvalappil, Rajith</style></author><author><style face="normal" font="default" size="100%">Bhange, Siddheshwar N.</style></author><author><style face="normal" font="default" size="100%">Puthenpediakkal, Hasna</style></author><author><style face="normal" font="default" size="100%">Kurungot, Sreekumar</style></author></authors></contributors><titles><title><style face="normal" font="default" size="100%">Carbon nanohorn-derived graphene nanotubes as a platinum-free fuel cell cathode</style></title><secondary-title><style face="normal" font="default" size="100%">ACS Applied Materials &amp; Interfaces</style></secondary-title></titles><keywords><keyword><style  face="normal" font="default" size="100%">carbon nanohorns</style></keyword><keyword><style  face="normal" font="default" size="100%">carbon nanotube</style></keyword><keyword><style  face="normal" font="default" size="100%">electrocatalyst</style></keyword><keyword><style  face="normal" font="default" size="100%">fuel cell</style></keyword><keyword><style  face="normal" font="default" size="100%">oxygen reduction reaction</style></keyword></keywords><dates><year><style  face="normal" font="default" size="100%">2015</style></year><pub-dates><date><style  face="normal" font="default" size="100%">NOV</style></date></pub-dates></dates><number><style face="normal" font="default" size="100%">43</style></number><publisher><style face="normal" font="default" size="100%">AMER CHEMICAL SOC</style></publisher><pub-location><style face="normal" font="default" size="100%">1155 16TH ST, NW, WASHINGTON, DC 20036 USA</style></pub-location><volume><style face="normal" font="default" size="100%">7</style></volume><pages><style face="normal" font="default" size="100%">24256-24264</style></pages><language><style face="normal" font="default" size="100%">eng</style></language><abstract><style face="normal" font="default" size="100%">&lt;p&gt;Current low-temperature fuel cell research mainly focuses on the development of efficient nonprecious electrocatalysts for the reduction of dioxygen molecule due to the reasons like exorbitant cost and scarcity of the current state-of-the-art Pt-based catalysts. As a potential alternative to such costly electrocatalysts, we report here the preparation of an efficient graphene nanotube based oxygen reduction electrocatalyst which has been derived from single walled nanohorns, comprising a thin layer of graphene nanotubes and encapsulated iron oxide nanopartides (FeGNT). FeGNT shows a surface area of 750 m(2)/g, which is the highest ever reported among the metal encapsulated nanotubes. Moreover, the graphene protected iron oxide nanoparticles assist the system to attain efficient distribution of Fe-N-x and quaternary nitrogen based active reaction centers, which provides better activity and stability toward the oxygen reduction reaction (ORR) in acidic as well as alkaline conditions. Single cell performance of a proton exchange membrane fuel cell by using FeGNT as the cathode catalyst delivered a maximum power density of 200 mW cm(-2) with Nafion as the proton exchange membrane at 60 degrees C. The facile synthesis strategy with iron oxide encapsulated graphitic carbon morphology opens up a new horizon of hope toward developing Pt-free fuel cells and metal-air batteries along with its applicability in other energy conversion and storage devices.&lt;/p&gt;</style></abstract><issue><style face="normal" font="default" size="100%">43</style></issue><custom3><style face="normal" font="default" size="100%">&lt;p&gt;Foreign&lt;/p&gt;</style></custom3><custom4><style face="normal" font="default" size="100%">7.145</style></custom4></record><record><source-app name="Biblio" version="7.x">Drupal-Biblio</source-app><ref-type>17</ref-type><contributors><authors><author><style face="normal" font="default" size="100%">Bhange, Siddheshwar N.</style></author><author><style face="normal" font="default" size="100%">Soni, Roby</style></author><author><style face="normal" font="default" size="100%">Singla, Gourav</style></author><author><style face="normal" font="default" size="100%">Ajithkumar, T. G.</style></author><author><style face="normal" font="default" size="100%">Kurungot, Sreekumar</style></author></authors></contributors><titles><title><style face="normal" font="default" size="100%">FeNx/FeSx-anchored carbon sheet-carbon nanotube composite electrocatalysts for oxygen reduction</style></title><secondary-title><style face="normal" font="default" size="100%">ACS Applied Nano Materials</style></secondary-title></titles><keywords><keyword><style  face="normal" font="default" size="100%">carbon nanotube</style></keyword><keyword><style  face="normal" font="default" size="100%">electrocatalyst</style></keyword><keyword><style  face="normal" font="default" size="100%">fuel cell</style></keyword><keyword><style  face="normal" font="default" size="100%">oxygen reduction reaction</style></keyword><keyword><style  face="normal" font="default" size="100%">Pt-free ORR</style></keyword></keywords><dates><year><style  face="normal" font="default" size="100%">2020</style></year><pub-dates><date><style  face="normal" font="default" size="100%">MAR</style></date></pub-dates></dates><volume><style face="normal" font="default" size="100%">3</style></volume><pages><style face="normal" font="default" size="100%">2234-2245</style></pages><language><style face="normal" font="default" size="100%">eng</style></language><abstract><style face="normal" font="default" size="100%">&lt;p&gt;Even though various Pt-free electrocatalysts for oxygen reduction reaction (ORR) have been introduced, many of them are found to be active only in alkaline conditions. Considering Nafion, phosphoric acid-doped polybenzimidazole (PBI), and so on as the prominent ionomer membranes, used in the commercially available polymer electrolyte membrane fuel cells (PEMFCs), it becomes important that any development on the Pt-free catalysts should ensure the better ORR performance under acidic conditions. The present work effectively tackles this issue, where an ORR-based catalyst could be prepared with simultaneous incorporation of both Fe-N and Fe-S active sites on in situ generated carbon sheets which are spatially separated by the carbon nanotube (CNT) network. This catalyst shows ability to perform under both acidic and basic conditions. This has been achieved by growing a polyethylenedioxythiophene polymer network in the presence of CNT and melamine followed by its pyrolysis under an inert atmosphere. The catalyst formed at 900 degrees C (PMCNT-900) displays 0.94 V onset potential for ORR under acidic electrolyte conditions, which corresponds to 60 mV overpotential compared to its 40 wt % Pt/C counterpart. Interestingly, in single cell demonstration of Nafion-based PEMFC with PMCNT-900 as the cathode catalyst, the system delivered a maximum power density (PD) of 500 and 275 mW/cm(2) at 60 degrees C under H-2-O-2 and H-2-air feed conditions, respectively. On the other hand, in a single cell test in the anion exchange membrane fuel cell (AEMFC) mode, a maximum power density of 65 mW/cm(2) at 50 degrees C could be achieved with the same cathode catalyst, which is a comparable value obtained while employing Pt/C as the cathode. These results, thus, infer to the efficiency of the catalyst to facilitate ORR under the extreme pH conditions, and particularly its performance under acidic condition reveals its prospect as a potential Pt-free electrocatalyst to serve in the Nafion-based systems.&lt;/p&gt;
</style></abstract><issue><style face="normal" font="default" size="100%">3</style></issue><work-type><style face="normal" font="default" size="100%">Article</style></work-type><custom3><style face="normal" font="default" size="100%">&lt;p&gt;Foreign&lt;/p&gt;
</style></custom3><custom4><style face="normal" font="default" size="100%">&lt;p&gt;3.939&lt;/p&gt;
</style></custom4></record><record><source-app name="Biblio" version="7.x">Drupal-Biblio</source-app><ref-type>17</ref-type><contributors><authors><author><style face="normal" font="default" size="100%">Kumar, Sachin</style></author><author><style face="normal" font="default" size="100%">Bhange, Siddheshwar N.</style></author><author><style face="normal" font="default" size="100%">Soni, Roby</style></author><author><style face="normal" font="default" size="100%">Kurungot, Sreekumar</style></author></authors></contributors><titles><title><style face="normal" font="default" size="100%">WO3 nanorods bearing interconnected Pt nanoparticle units as an activity-modulated and corrosion-resistant carbon-free system for polymer electrolyte membrane fuel cells</style></title><secondary-title><style face="normal" font="default" size="100%">ACS Applied Energy Materials</style></secondary-title></titles><keywords><keyword><style  face="normal" font="default" size="100%">Carbon-free</style></keyword><keyword><style  face="normal" font="default" size="100%">electrocatalyst</style></keyword><keyword><style  face="normal" font="default" size="100%">fuel cell</style></keyword><keyword><style  face="normal" font="default" size="100%">oxygen reduction reaction</style></keyword><keyword><style  face="normal" font="default" size="100%">tungsten oxide</style></keyword></keywords><dates><year><style  face="normal" font="default" size="100%">2020</style></year><pub-dates><date><style  face="normal" font="default" size="100%">FEB</style></date></pub-dates></dates><volume><style face="normal" font="default" size="100%">3</style></volume><pages><style face="normal" font="default" size="100%">1908-1921</style></pages><language><style face="normal" font="default" size="100%">eng</style></language><abstract><style face="normal" font="default" size="100%">&lt;p&gt;Commercial platinum-supported carbon (Pt/C) catalyst is the most widely used oxygen reduction reaction (ORR) electrocatalyst in polymer electrolyte membrane fuel cells (PEMFCs). However, carbon oxidation in Pt/C during the operation of PEMFCs poses serious issues, particularly in meeting long-term durability of the cells. Although carbon-free Pt-based catalysts are considered to be the best alternatives, the single-cell performances reported for many such systems are found to be inferior to that of the carbon-based systems. As a practical way to realize a carbon-free electrocatalyst, we have developed a system by dispersing an interconnected Pt nanoparticle network on the nanorods of tungsten oxide (WO3). Uniform dispersion of the WO3 nanorods by fine and more or less interconnected Pt nanoparticles (20 wt %) is a key feature of the electrocatalyst. This has helped the system to achieve an intrinsic ORR characteristics which is very similar to that of Pt/C, as reflected from the comparative analysis of the onset potential, half-wave potential, limiting current density, and the number of electrons transferred in the ORR process. Pt/WO3 also shows better stability under start-stop accelerated potential cycling after 10 000 cycles, compared to Pt/C. The relative decrement in the electrochemically active surface area (ECSA) for Pt/WO3 nanorods was negligible, compared to the similar to 26% decrement registered by Pt/C under the identical testing conditions. Finally, a system-level validation in a single-cell model of PEMFC by fabricating a membrane electrode assembly (MEA) with Pt/WO3 as both the anode and cathode catalyst delivered comparable output power density as that of a similar system fabricated by using Pt/C. ECSA comparison in MEA shows the potential use of Pt/WO3-400 as the catalyst for the fuel cells, since it is exhibiting an ECSA value that is 3.4 greater than that of Pt/C at a Pt loading of 0.5 mg cm(-2).&lt;/p&gt;
</style></abstract><issue><style face="normal" font="default" size="100%">2</style></issue><work-type><style face="normal" font="default" size="100%">Article</style></work-type><custom3><style face="normal" font="default" size="100%">&lt;p&gt;Foreign&lt;/p&gt;
</style></custom3><custom4><style face="normal" font="default" size="100%">&lt;p&gt;4.473&lt;/p&gt;
</style></custom4></record></records></xml>