01898nas a2200205   4500008004100000245006600041210006600107260010600173300001400279490000700293520119700300653001101497653001801508653001601526653001801542653000801560653001501568100002301583856008601606       2008                        eng d00aExperimental analysis of the lift force on bubbles in a swarm0 aExperimental analysis of the lift force on bubbles in a swarm  aTHE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, ENGLANDbPERGAMON-ELSEVIER SCIENCE LTDcOCT  a1710-17230 v633 a<p>The lift force acting on bubbles in a swarm has been estimated by analyzing the instantaneous velocity-time data obtained using LDA in a cylindrical bubble column. Phase distinction was achieved through the multiresolution analysis of the velocity-time data. Several important issues related to the transverse motion of bubbles subjected to a shear field have been discussed quantitatively. The actually measured bubble sizes, the respective slip velocity values in transverse and axial directions and the local shear rates (gamma) enabled the verification of known formulations for the lift coefficient (C-L) for bubbles. At many locations in the column the radial flux of the gas phase by turbulent dispersion and the radial slip were estimated. The radially inward movement of bubbles from low to high axial velocity (from column wall to center, i.e., C-L &lt; 0) was observed at most of the measurement locations. The local lift coefficient was estimated using the transverse drag force and the values support the results from the material balance approach. The estimated C-L values showed a wide variation over the column cross-section. (c) 2007 Elsevier Ltd. All rights reserved.</p>10aBubble10aBubble column10abubble size10ahydrodynamics10aLDA10alift force1 aKulkarni, Amol, A.  uhttps://library.ncl.res.in/content/experimental-analysis-lift-force-bubbles-swarm01807nas a2200229   4500008004100000022001400041245008200055210006900137260006700206300001400273490000700287520101300294653001401307653001801321653002901339653001301368653001401381100002701395700001701422700002301439856011501462       2014                        eng d  a0008-403400aTwo-phase flow in metal monoliths: hydrodynamics and liquid-liquid extraction0 aTwophase flow in metal monoliths hydrodynamics and liquidliquid   a111 RIVER ST, HOBOKEN 07030-5774, NJ USAbWILEY-BLACKWELLcDEC  a2166-21750 v923 a<p>This work aims to explore the application of metal monoliths as a scale-up option for efficient liquid-liquid extraction. The pressure drop, mass transfer and residence time distribution are measured for low Ca (approximate to 10(-5)) with monoliths having three different cell densities. The cross-over section between two monoliths was seen to enhance mixing in the column. However, the RTD of two-phase liquid-liquid up-flow was inferior to the single phase RTD. For higher cell density substrates, the cross-over zones seem to cause trapping of slugs due to non-superimposing channel ends. Relatively high shear rates through the film of continuous phase helped enhance the mass transfer rates, thereby helping to achieve the desired extraction in a short column. The entrance sections and cross-over zones between the monoliths adversely affected the extraction for higher cell density monoliths. The analysis of data supports use of low cell density monolith for better performance and scale up.</p>10acapillary10ahydrodynamics10aliquid-liquid extraction10amonolith10aslug flow1 aDeshpande, Jaydeep, B.1 aGosavi, Abha1 aKulkarni, Amol, A.  uhttps://library.ncl.res.in/content/two-phase-flow-metal-monoliths-hydrodynamics-and-liquid-liquid-extraction-0