01738nas a2200169 4500008004100000022001400041245009500055210006900150260008000219300001400299490000700313520106700320100001901387700002001406700001801426856012401444 2007 eng d a0022-372700aPoly(o-anisidine) films on mild steel: electrochemical synthesis and biosensor application0 aPolyoanisidine films on mild steel electrochemical synthesis and aDIRAC HOUSE, TEMPLE BACK, BRISTOL BS1 6BE, ENGLANDbIOP PUBLISHING LTDcAPR a2555-25620 v403 a

Poly(o-anisidine) (POA) films were synthesized on mild steel from an aqueous oxalic acid solution by electrochemical polymerization of o-anisidine using cyclic voltammetry. These films were characterized by cyclic voltammetry, UV-visible absorption spectroscopy, Fourier transform infrared (FTIR) spectroscopy and scanning electron microscopy (SEM). The enzyme glucose oxidase (GOx) was entrapped into the POA film by a physical adsorption method. The resulting POA-GOx films were characterized by UV-visible absorption spectroscopy, FTIR and SEM. The amperometric response of the POA-GOx films was measured as a function of glucose concentration in phosphate buffer solution (pH 7.3). The POA-GOx films exhibited a fast amperometric response (1-5 s) and a linear response in the range of 2-20 mM glucose. The maximum current density and Michaelis-Menten constant of POA/GOx films were found to be similar to 406 mu A cm(-2) and 1.03 mM, respectively. The shelf stability, operational stability and thermal stability of these films were also investigated.

1 aPatil, Dewyani1 aGaikwad, A., B.1 aPatil, Pradip uhttps://library.ncl.res.in/content/polyo-anisidine-films-mild-steel-electrochemical-synthesis-and-biosensor-application01979nas a2200265 4500008004100000022001400041245007500055210006900130260007300199300001000272490000700282520111500289653001401404653001901418653001001437653003001447653000801477653000801485100001901493700001801512700002801530700002501558700002101583856010901604 2010 eng d a0039-914000aHighly sensitive and fast responding CO sensor based on Co3O4 nanorods0 aHighly sensitive and fast responding CO sensor based on Co3O4 na aPO BOX 211, 1000 AE AMSTERDAM, NETHERLANDSbELSEVIER SCIENCE BVcAPR a37-430 v813 a

Co3O4 nanorods (diameters similar to 6-8 nm and lengths similar to 20-30 nm) were synthesized for the first time through a simple co-precipitation/digestion method by calcination of cobalt hydroxyl carbonate in air and their CO gas sensing properties were investigated. The Co3O4 nanorods exhibited outstanding gas sensing characteristics such as, higher gas response (similar to 6.55-50 ppm CO gas at 250 degrees C), extremely rapid response (similar to 3-4s), fast recovery (similar to 5-6s), excellent repeatability, good selectivity and lower operating temperature (similar to 250 degrees C). Furthermore, the Co3O4 nanorods are able to detect up to 5 ppm for CO with reasonable sensitivity (similar to 3.32) at an operating temperature 250 degrees C and they can be reliably used to monitor the concentration of CO over the range (5-50 ppm). The experimental results clearly demonstrate the potential of using the Co3O4 nanorods as sensing material in the fabrication of CO sensors. Plausible CO sensing mechanism of the Co3O4 nanorods is also discussed. (C) 2009 Elsevier B.V. All rights reserved.

10aCO sensor10aCo3O4 nanorods10aHRTEM10aSemiconductor gas sensors10aXPS10aXRD1 aPatil, Dewyani1 aPatil, Pradip1 aSubramanian, Vijayanand1 aJoy, Pattayil, Alias1 aPotdar, Hari, S. uhttps://library.ncl.res.in/content/highly-sensitive-and-fast-responding-co-sensor-based-co3o4-nanorods-002396nas a2200253 4500008004100000022001400041245007600055210006900131260006900200300001200269490000800281520158200289653002501871653001001896653001501906653003001921653000801951653000801959653000801967100001901975700002001994700001802014856011002032 2011 eng d a0925-400500aHighly sensitive and selective LPG sensor based on alpha-Fe2O3 nanorods0 aHighly sensitive and selective LPG sensor based on alphaFe2O3 na aPO BOX 564, 1001 LAUSANNE, SWITZERLANDbELSEVIER SCIENCE SAcMAR a299-3060 v1523 a

The alpha-Fe2O3 nanorods were successfully synthesized without any templates by calcining the alpha-FeOOH precursor in air at 300 degrees C for 2 h and their LPG sensing characteristics were investigated. The alpha-FeOOH precursor was prepared through a simple and low cost wet chemical route at low temperature (40 degrees C) using FeSO4 center dot 7H(2)O and CH3COONa as starting materials. The formation of alpha-FeOOH precursor and its topotactic transformation to alpha-Fe2O3 upon calcination was confirmed by X-ray diffraction measurement (XRD). X-ray photoelectron spectroscopy (XPS), field emission scanning electron microscopy (FESEM) and transmission electron microscopy (TEM) analysis. The alpha-Fe2O3 nanorods exhibited outstanding gas sensing characteristics such as, higher gas response (similar to 1746-50 ppm LPG at 300 degrees C), extremely rapid response (similar to 3-4 s), relatively slow recovery (similar to 8-9 min), excellent repeatability, good selectivity and lower operating temperature (similar to 300 degrees C). Furthermore, the alpha-Fe2O3 nanorods are able to detect up to 5 ppm for LPG with reasonable response (similar to 15) at the operating temperature of 300 degrees C and they can be reliably used to monitor the concentration of LPG over the range (5-60 ppm). The experimental results clearly demonstrate the potential of using the alpha-Fe2O3 nanorods as sensing material in the fabrication of LPG sensors. Plausible LP G sensing mechanism of the alpha-Fe2O3 nanorods is also discussed. (C) 2010 Elsevier B.V. All rights reserved.

10aalpha-Fe2O3 nanorods10aFESEM10aLPG sensor10aSemiconductor gas sensors10aTEM10aXPS10aXRD1 aPatil, Dewyani1 aPatil, Virendra1 aPatil, Pradip uhttps://library.ncl.res.in/content/highly-sensitive-and-selective-lpg-sensor-based-alpha-fe2o3-nanorods-001700nas a2200181 4500008004100000022001400041245013500055210006900190260012500259300001100384490000800395520091000403100001901313700001801332700002101350700001801371856012901389 2011 eng d a0021-897900aInvestigation of poly(o-anisidine)-SnO2 nanocomposites for fabrication of low temperature operative liquefied petroleum gas sensor0 aInvestigation of polyoanisidineSnO2 nanocomposites for fabricati aCIRCULATION & FULFILLMENT DIV, 2 HUNTINGTON QUADRANGLE, STE 1 N O 1, MELVILLE, NY 11747-4501 USAbAMER INST PHYSICScDEC a1245010 v1103 a

Poly(o-anisidine)-tin oxide (POA-SnO2) nanocomposites has been investigated for the fabrication of low temperature operative (100 degrees C) liquefied petroleum gas (LPG) sensor. The POA-SnO2 nanocomposites have been synthesized through an in situ chemical polymerization of o-anisidine in presence of SnO2 nanoparticles. The POA-SnO2 nanocomposite shows better LPG sensing properties than that of pure POA. The nanocomposite with 50 wt. % SnO2 exhibits an excellent LPG sensing characteristics at the operating temperature of 100 degrees C such as higher relative gas response (similar to 23.47% to 3.4% of LPG), extremely rapid response (similar to 6 s), fast recovery (similar to 33 s), good reproducibility, and remarkable selectivity. The application of POA-SnO2 nanocomposites for fabrication of the LPG sensor was demonstrated. (C) 2011 American Institute of Physics. [doi:10.1063/1.3667107]

1 aPatil, Dewyani1 aKolhe, Kishor1 aPotdar, Hari, S.1 aPatil, Pradip uhttps://library.ncl.res.in/content/investigation-polyo-anisidine-sno2-nanocomposites-fabrication-low-temperature-operative-002164nas a2200253 4500008004100000022001400041245005900055210005900114260006900173300001200242490000800254520136200262653001001624653001501634653002701649653003001676653000801706100002801714700002501742700002101767700001901788700001801807856008501825 2011 eng d a0925-400500aNanostructured spinet ZnCo2O4 for the detection of LPG0 aNanostructured spinet ZnCo2O4 for the detection of LPG aPO BOX 564, 1001 LAUSANNE, SWITZERLANDbELSEVIER SCIENCE SAcFEB a121-1290 v1523 a

Nanostrucutred spinel ZnCo2O4 (similar to 26-30 nm) was synthesized by calcining the mixed precursor (consisting of cobalt hydroxyl carbonate and zinc hydroxyl carbonate) in air at 600 degrees C for 5 h. The mixed precursor was prepared through a low cost and simple co-precipitation/digestion method. The transformation of the mixed precursor into nanostructured spinel ZnCO2O4 upon calcinations was confirmed by X-ray diffraction (XRD) measurement, thermogravimetric analysis (TGA), X-ray photoelectron spectroscopy (XPS) and high resolution transmission electron microscopy (HRTEM). To demonstrate the potential applicability of ZnCo2O4 spinel in the fabrication of gas sensors, its LPG sensing characteristics were systematically investigated. The ZnCo2O4 spinel exhibited outstanding gas sensing characteristics such as, higher gas response (similar to 72-50 ppm LPG gas at 350 degrees C), response time (similar to 85-90 s), recovery time (similar to 75-80 s), excellent repeatability, good selectivity and relatively lower operating temperature (similar to 350 degrees C). The experimental results demonstrated that the nanostructured spinel ZnCo2O4 is a very promising material for the fabrication of LPG sensors with good sensing characteristics. Plausible LPG sensing mechanism is also discussed. (c) 2010 Elsevier B.V. All rights reserved.

10aHRTEM10aLPG sensor10aNanostructured ZnCo2O410aSemiconductor gas sensors10aXPS1 aVijayanand, Subramanian1 aJoy, Pattayil, Alias1 aPotdar, Hari, S.1 aPatil, Dewyani1 aPatil, Pradip uhttps://library.ncl.res.in/content/nanostructured-spinet-znco2o4-detection-lpg-0