01830nas a2200205   4500008004100000022001400041245010600055210006900161260009900230300001400329490000700343520102100350653001801371653001401389653003901403653001101442100003101453700002001484856012001504       2008                        eng d  a0960-852400aBiocomposites of cellulose reinforced starch: improvement of properties by photo-induced crosslinking0 aBiocomposites of cellulose reinforced starch improvement of prop  aTHE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLANDbELSEVIER SCI LTDcDEC  a8803-88090 v993 a<p>In the present study, the composite films have been prepared from the aqueous dispersions of starch with microcrystalline cellulose using glycerol as plasticizer and irradiated under ultraviolet (UV) light using sodium benzoate as photo-sensitizer. Photocrosslinking was characterized by measuring the water absorption under 100% relative humidity, swelling degree and gel fraction in dimethylsulphoxide (DMSC), upon irradiation time. Both, the incorporation of cellulose and photo-irradiation were found to decrease the water absorption, swelling in DMSO and increase the gel fraction. Thermal transitions indicated the anti-plasticization of amylopectin chains at the fiber/matrix interface. With increasing content of cellulose and photo-irradiation time, the tensile modulus and strength were found to improve. It is summarized that the combination of cellulose reinforcement and photo-crosslinking of matrix has improved the physical and mechanical properties. (C) 2008 Elsevier Ltd. All rights reserved.</p>10aBiocomposites10acellulose10aPhoto-irradiation and crosslinking10aStarch1 aKumar, Annamalai, Pratheep1 aSingh, Raj, Pal  uhttps://library.ncl.res.in/content/biocomposites-cellulose-reinforced-starch-improvement-properties-photo-induced-002137nas a2200253   4500008004100000022001400041245012900055210006900184260005700253300001400310490000700324520121300331653001501544653001401559653001901573653001801592653001801610653002201628100003101650700002801681700002601709700002001735856012801755       2010                        eng d  a1598-503200aPreparation and characterization of bioceramic nanocomposites based on hydroxyapatite (HA) and carboxymethyl cellulose (CMC)0 aPreparation and characterization of bioceramic nanocomposites ba  a233 SPRING ST, NEW YORK, NY 10013 USAbSPRINGERcDEC  a1160-11670 v183 a<p>We report the synthesis of biomimetic nanocomposites based on carboxymethyl cellulose (CMC) and hydroxyapatite (HA) nanoparticles via a co-precipitation method. Physico-chemical characterization was performed before and after calcination by Fourier transform infrared (FTIR) spectroscopy, solid state (31)P nuclear magnetic resonance (NMR) spectroscopy, and thermogravimetric analysis (TGA). The formation of nanocomposites was observed by wide angle X-ray diffraction (WAXD), scanning electron microscopy (SEM) with energy dispersive X-ray analysis (EDX), and transmission electron microscopy (TEM). The spectral and crystallographic data indicated the formation of hydroxyapatite in the presence of CMC. They were observed as aggregates of HA nanoparticles and CMC, whose sizes were approximately similar to 260 +/- 40 nm. The crystallite size of the hydroxyapatite particles decreased (with 2 wt% 18 +/- 3 nm) with increasing CMC content. The morphological aspects of the calcined samples revealed the sintering ability of HA nanoparticles. Nanocomposites of hydroxyapatite nanoparticles that mimic the process of nucleation and growth in nature can be prepared using biomacromolecules such as CMC.</p>10abiopolymer10acellulose10ahydroxyapatite10aNanoparticles10aParticle size10aX-ray diffraction1 aKumar, Annamalai, Pratheep1 aMohaideen, Kamal, Khaja1 aAlariqi, Sameh, A. S.1 aSingh, Raj, Pal  uhttps://library.ncl.res.in/content/preparation-and-characterization-bioceramic-nanocomposites-based-hydroxyapatite-ha-and-0