02300nas a2200253 4500008004100000022001400041245010400055210006900159260007900228300001200307490000700319520138300326653001601709653001401725653001601739653001301755653002501768100002201793700003201815700002401847700002101871700002201892856013201914 2016 eng d a2194-574800aDifferentiating process performance of various coagulants in removal of congo red and orange G dyes0 aDifferentiating process performance of various coagulants in rem aGENTHINER STRASSE 13, D-10785 BERLIN, GERMANYbWALTER DE GRUYTER GMBHcFEB a195-2110 v143 a

Two refractory azo dyes-Congo red and Orange G, especially at high concentrations were subjected to coagulation with different conventional coagulants and newer formulations developed from Aluminum sulfate, Iron (III) chloride, Aluminium chloride, Poly diallydimethylammonium chloride (Poly DADMAC) and Poly Aluminium Chloride (PAC). The highest COD reduction of 99 % was obtained with PAC SAB 18 (Powder Grade PAC) for Congo red at pH 4.5 while the color removal of 99 % was achieved with almost all the coagulants in the present study at specific pH within 3-8. The optimum dose for the iron-based coagulant is 200 mg/L while that of aluminum-based coagulants and PAC is 150-200 mg/L. Results showed that Orange G was more difficult to remove with a maximum COD removal of 65 % and 35 % color removal using various formulations. The combinational formulations of inorganic-inorganic and inorganic- organic produced a substantial enhancement in COD and color removal and reduced sludge. PAC-Fe30/70 produces the minimum sludge of 50 mL/g on Congo red. pH in the range 3-9 showed high reductions in COD and color (90-99 %) for Congo red while jerky rise in COD and color reduction was observed in the case of Orange G after pH 9. An attempt to understand the dye coagulation mechanism has been made based on the specific difference in dye structure and cation speciation.

10acoagulation10aCongo red10adye removal10aOrange G10aWastewater treatment1 aPrajapati, Kavita1 aSorokhaibam, Laxmi, Gayatri1 aBhandari, Vinay, M.1 aKilledar, D., J.1 aRanade, Vivek, V. uhttps://library.ncl.res.in/content/differentiating-process-performance-various-coagulants-removal-congo-red-and-orange-g-dyes-002328nas a2200253 4500008004100000022001400041245006700055210006700122260007100189300001400260490000600274520150100280653001601781653001601797653002301813653001701836653001401853100001701867700003201884700002401916700001301940700002201953856009901975 2016 eng d a2168-048500aGreen approach to dye wastewater treatment using biocoagulants0 aGreen approach to dye wastewater treatment using biocoagulants a1155 16TH ST, NW, WASHINGTON, DC 20036 USAbAMER CHEMICAL SOCcMAY a2495-25070 v43 a

The present study focuses on newer biocoagulants, bioformulations, and the understanding of coagulant behavior with biocoagulants in relation to chemical coagulants. Newer biocoagulants, seeds of Azadirachta indica (AI) and pads of Acanthocereus tetragonus, are discussed along with two known biocoagulants, Moringa oleifera and Cicer arietinum seeds. Dye removal studies were carried out using widely reported Congo red dye to facilitate easy comparison with other conventional coagulants and the effect of various parameters such as initial dye concentration, pH, coagulant dose, etc. are discussed in detail. The use of biocoagulant was found to be highly effective, and up to 99% dye removal was achieved for coagulant doses in the range of 300-1500 mg/L. It was also observed that coagulation is pH sensitive, similar to chemical coagulants. Although the biocoagulant dose is relatively higher than the conventional chemical coagulants, a good value for the sludge volume index, similar to 50 mL/g for 1 h and 30 min, respectively, was obtained for the two coagulants, Acanthocereus tetragonus and Moringa oleifera. A very high particle count compared to chemical coagulants was observed using a focused beam reflectance measurement. Bioformulation with chemical coagulants such as alum, ferric, and aluminum based coagulants can, not only lower doses of biocoagulants (up to one-third) but can also result in significant improvement in the coagulation performance, up to 50% or more.

10acoagulation10adye removal10aEffluent treatment10aflocculation10apollution1 aChethana, M.1 aSorokhaibam, Laxmi, Gayatri1 aBhandari, Vinay, M.1 aRaja, S.1 aRanade, Vivek, V. uhttps://library.ncl.res.in/content/green-approach-dye-wastewater-treatment-using-biocoagulants02440nas a2200265 4500008004100000022001400041245011000055210006900165260000800234300001400242490000700256520159200263653001501855653001201870653001701882653001601899653001701915653001501932100002101947700001901968700002001987700002102007700002402028856012202052 2023 eng d a1618-954X00aDevelopment of multipurpose biomass-derived adsorbents using Coccinia grandis for removal of contaminants0 aDevelopment of multipurpose biomassderived adsorbents using Cocc cDEC a3393-34050 v253 a

The present study is an attempt to develop newer multipurpose biomass-derived adsorbents for water and wastewater treatment; biomass that are easily available, renewable and most importantly, sustainable. A model adsorbent was developed using Coccinia grandis (CG, Ivy gourd) and further modified by impregnating copper nanoparticles (CG-Cu). The adsorbent characterization was done for evaluating surface morphology, surface area and metal modification. The utility of the newer adsorbents was established for the removal of different contaminants such as dyes (cationic Malachite Green, anionic Congo Red and fluorescent cationic Rhodamine B), Active Pharmaceutical Ingredient pollutant (Ciprofloxacin) and also for the removal of pathogenic bacteria, Gram-negative Escherichia coli. Both CG and CG-Cu bio-nanocomposite were highly effective in removal of different contaminants, 99% dye removal for Malachite Green, with a high adsorption capacity of 49 mg/g, higher than that for commercial activated charcoal whereas for all other dyes, the performance of CG-Cu was similar. The isotherm studies indicated multilayer adsorption, in general. A good adsorption capacity of 10.8 mg/g was also observed for the removal of ciprofloxacin. The combined effect of the bio-nanocomposite, CG-Cu was impressive and 100% disinfection was achieved within 10 min, due to the antimicrobial activity of Cu and oxidation effect of reactive oxygen species enhancing the disinfection.Graphical abstractMultipurpose biomass derived adsorbents using Coccinia grandis for removal of contaminants

10aAdsorption10aBiomass10aDisinfection10adye removal10ananomaterial10aSeparation1 aRaj, Surabhi, S.1 aMane, Maya, B.1 aThanekar, Pooja1 aBalapure, Kshama1 aBhandari, Vinay, M. uhttps://library.ncl.res.in/content/development-multipurpose-biomass-derived-adsorbents-using-coccinia-grandis-removal