02005nas a2200253   4500008004100000022001400041245011800055210006900173260009900242300001200341490000700353520106500360653001801425653001401443653002001457653002601477653001501503653001801518100002601536700002001562700001901582700001801601856013201619       2009                        eng d  a0141-391000aEffect of gamma-dose rate on crystallinity and morphological changes of gamma-sterilized biomedical polypropylene0 aEffect of gammadose rate on crystallinity and morphological chan  aTHE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLANDbELSEVIER SCI LTDcFEB  a272-2770 v943 a<p>The present work is aimed to study the changes in crystallinity and morphology of biomedical polyolefins after gamma-sterilization. The isotactic polypropylene (iPP) films were sterilized by gamma-radiation and the changes were characterized by differential scanning calorimetry (DSC), wide angle X-ray diffraction (WAXD) and atomic force microscopy (AFM) techniques. The effect of dose rate on crystallinity changes also was focused. It was found that crystallinity and morphology significantly changed with gamma-irradiation. There was an increase in crystallinity Lip to 10 kGy accompanied with decrease in viscosity and mechanical properties. The changes in crystallinity mainly depend on gamma-irradiation dose and dose rate. The rise in crystallinity was attributed to chain scission and forming new perfect lamellae. However, the reduction was accompanied by occurrence of gamma- and beta-phases and crosslinking. Possible explanations for transitions in phases are also discussed based on our results. (C) 2008 Elsevier Ltd. All rights reserved.</p>10aCrystallinity10aDose rate10aGamma radiation10amechanical properties10aMorphology10apolypropylene1 aAlariqi, Sameh, A. S.1 aKumar, Pratheep1 aRao, B., S. M.1 aSingh, R., P.  uhttps://library.ncl.res.in/content/effect-gamma-dose-rate-crystallinity-and-morphological-changes-gamma-sterilized-biomedical-001945nas a2200217   4500008004100000022001400041245009800055210006900153260008000222300001000302490000700312520112900319653003701448653001401485653002201499653001801521100002601539700001801565700001901583856012501602       2011                        eng d  a1319-802500aGamma-initiated oxidation of isotactic polypropylene: effect of gamma-dose rate on durability0 aGammainitiated oxidation of isotactic polypropylene effect of ga  aTIERGARTENSTRASSE 17, D-69121 HEIDELBERG, GERMANYbSPRINGER HEIDELBERGcJAN  a29-380 v363 a<p>The effect of gamma-irradiation dose rate on the chemical, molecular, and mechanical properties of isotactic polypropylene (iPP) films was investigated using three different Co-60 sources with dose rates of 600, 660, and 780 Gy h(-1). Fourier transform infrared spectroscopy coupled with chemical derivatization with NO and SF4, and measurements of the elongation at break, toughness, and molecular weight were used to describe the effects of gamma-dose rate on iPP. It was found that the formation of oxidation products depended significantly on the dose rate. However, the kinetic accumulation of ketones were more sensitive to the dose rate of gamma source. Degradation induced by gamma-radiation depends on the dose rate-the degradation of mechanical properties was more significant at a low dose rate than at a high dose rate. It was found that the lower the dose rate, the higher the degree of oxidation in terms of the formation of gamma-products. The mechanism of gamma-degradation is discussed based on the correlation between the changes in chemical and physical properties upon exposure to gamma-radiation.</p>10aChemical and physical properties10aDose rate10agamma-irradiation10apolypropylene1 aAlariqi, Sameh, A. S.1 aSingh, R., P.1 aRao, B., S. M.  uhttps://library.ncl.res.in/content/gamma-initiated-oxidation-isotactic-polypropylene-effect-gamma-dose-rate-durability-0