01980nas a2200277   4500008004100000022001400041245010100055210006900156260000800225300001400233490000700247520102500254653002901279653002201308653002101330653002101351653002301372100002701395700002901422700001501451700002301466700003101489700002301520700003001543856012901573       2018                        eng d  a1433-785100aFlexible composite mechanical energy harvester from a ferroelectric organoamino phosphonium salt0 aFlexible composite mechanical energy harvester from a ferroelect  cJUL  a9054-90580 v573 a<p>A new binary organic salt diphenyl diisopropylamino phosphonium hexaflurophosphate (DPDPPF6) was shown to exhibit a good ferroelectric response and employed for mechanical energy harvesting application. The phosphonium salt crystallizes in the monoclinic noncentrosymmetric space group Cc and exhibits an H-bonded 1D chain structure due to N-HF interactions. Ferroelectric measurements on the single crystals of DPDPPF6 gave a well-saturated rectangular hysteresis loop with a remnant (P-r) polarization value of 6Ccm(-2). Further, composite devices based on polydimethylsiloxane (PDMS) films for various weight percentages (3, 5, 7, 10 and 20wt%) of DPDPPF6 were prepared and examined for power generation by using an impact test setup. A maximum output peak-to-peak voltage (V-PP) of 8.5V and an output peak-to-peak current (I-PP) of 0.5A was obtained for the non-poled composite film with 10wt% of DPDPPF6. These results show the efficacy of organic ferroelectric substances as potential micropower generators.</p>10abinary phosphonium salts10aenergy conversion10aferroelectricity10ahydrogen bonding10apolymer composites1 aVijayakanth, Thangavel1 aSrivastava, Anant, Kumar1 aRam, Farsa1 aKulkarni, Priyangi1 aShanmuganathan, Kadhiravan1 aPraveenkumar, Balu1 aBoomishankar, Ramamoorthy  uhttps://library.ncl.res.in/content/flexible-composite-mechanical-energy-harvester-ferroelectric-organoamino-phosphonium-salt02185nas a2200253   4500008004100000022001400041245011300055210006900168260000800237300001600245490000800261520131000269100001501579700001901594700001901613700002801632700001901660700001801679700002501697700002501722700002701747700003101774856012601805       2018                        eng d  a1932-744700aFluorinated nanocellulose-reinforced all-organic flexible ferroelectric nanocomposites for energy generation0 aFluorinated nanocellulosereinforced allorganic flexible ferroele  cJUL  a16540-165490 v1223 a<p>We report here enhanced ferroelectric crystal formation and energy generation properties of polyvinylidene fluoride (PVDF) in the presence of surface-modified crystalline nanocellulose. Incorporation of only 2-5 wt % fluorinated nanocellulose (FNC) in PVDF has been found to significantly induce polar beta/gamma-phase crystallization as compared to the addition of unmodified nanocellulose (carboxylated nanocellulose). A device made up of electrically poled PVDF/FNC composite films yielded 2 orders of magnitude higher voltage output than neat PVDF in vibrational energy harvesting. This remarkable increase in energy generation properties of PVDF at such a low loading of an organic natural biopolymer could be attributed to the tailored surface chemistry of nanocellulose, facilitating strong interfacial interactions between PVDF and FNC. Interestingly, energy harvesting devices fabricated from PVDF/FNC nanocomposites charged a 4.7 mu F capacitor at significantly faster rate and the accumulated voltage on capacitor was 3.8 times greater than neat PVDF. The fact that PVDF/FNC nanocomposites still retain a strain at break of 10-15% and can charge a capacitor in few seconds suggests potential use of these nanocomposites as flexible energy harvesting materials at large strain conditions.</p>1 aRam, Farsa1 aAmbone, Tushar1 aSharma, Aakash1 aMurugesan, Rajarathinam1 aKajale, Deepak1 aBorkar, Vivek1 aAli, Shaikh, Faruque1 aBalu, Praveen, Kumar1 aKumaraswamy, Guruswamy1 aShanmuganathan, Kadhiravan  uhttps://library.ncl.res.in/content/fluorinated-nanocellulose-reinforced-all-organic-flexible-ferroelectric-nanocomposites01889nas a2200229   4500008004100000245010700041210006900148260000800217300001000225490000800235520107000243100002801313700002201341700002101363700001501384700002901399700002601428700002201454700002601476700003101502856012601533       2018                        eng d00a Functionalized carbon nanotube reinforced polymer nanocomposite microcapsules with enhanced stiffness0 aFunctionalized carbon nanotube reinforced polymer nanocomposite   cAUG  a82-890 v5503 aMicrocapsules with tunable mechanical properties are highly desirable in pressure sensitive applications. We report here a facile approach to prepare polyurea/multiwall carbon nanotube (MWCNTs) nanocomposite microcapsules (MICs) with enhanced stiffness. A model compound dimethyl phthalate (DMP) was used as core material. MWCNTs were modified with reactive functional groups namely carboxyl (-COOH), amines (-NH2), and isocyanates (-NCO) to ensure a stronger interface between polymer wall and MWCNTs. Functionalization of MWCNTs was corroborated by Fourier transformed infrared spectroscopy (FTIR). Scanning electron microscopy (SEM) was employed to study the surface morphology of MICs. The presence of MWCNTs in the microcapsule wall was confirmed by transmission electron microscopy (TEM). MICs with functionalized MWCNTs show almost 100% increase in stiffness with respect to pristine capsules. All MICs show 92-97 +/- 1% encapsulation efficiency. The approach used in this paper can be broadly utilized to tune the mechanical properties of the microcapsules.1 aJagtap, Siddheshwar, B.1 aPatil, Vishal, D.1 aSuresh, Karthika1 aRam, Farsa1 aMohan, Muthu, Subramania1 aRajput, Shatruhan, S.1 aPatil, Shivprasad1 aShukla, Parshuram, G.1 aShanmuganathan, Kadhiravan  uhttps://library.ncl.res.in/content/functionalized-carbon-nanotube-reinforced-polymer-nanocomposite-microcapsules-enhanced