02436nas a2200157   4500008004100000022001400041245012800055210006900183260011000252300001600362490000600378520172400384100002302108700002902131856011802160       2013                        eng d  a2046-206900aInfluence of properties of SAPO's on the one-pot conversion of mono-, di- and poly-saccharides into 5-hydroxymethylfurfural0 aInfluence of properties of SAPOs on the onepot conversion of mon  aTHOMAS GRAHAM HOUSE, SCIENCE PARK, MILTON RD, CAMBRIDGE CB4 0WF, CAMBS, ENGLANDbROYAL SOC CHEMISTRYcJUL  a17156-171650 v33 a<p>Synthesis of 5-hydroxymethylfurfural (5-HMF) from biomass derived mono-and poly-saccharides is gaining importance because of its usefulness in the preparation of important chemicals. In our work, we have synthesized several silicoaluminophosphate (SAPO) catalysts, and have shown that in the absence of any other pH modifying reagents, those are active in converting mono-and poly-saccharides into 5-HMF under biphasic reaction condition at 175 degrees C. Particularly, SAPO-44 catalyst showed the best activity in the conversion of fructose to yield 78% 5-HMF with 88% selectivity. On the contrary, all other catalysts showed lower yields (H-MOR: 63%, SAPO-5: 32%, 2DCT: 60%). Over SAPO-44, good yields for 5-HMF were observed when glucose (67%), maltose (57%), cellobiose (56%) and starch (68%) were used as substrates. Recycle study carried out with SAPO-44 catalyst in the fructose conversion reaction showed marginal decrease in the activity up to 3rd run and then afterwards constant activity was observed up to 5th run (1st: 78%, 2nd: 71%, 3rd: 66%, 4th: 65%, 5th: 65%). Catalyst characterizations revealed that SAPO catalysts have higher hydrophilic nature than H-MOR (Si/Al = 10) and hence it is postulated that this property may help in achieving better results. Further studies on the catalyst characterizations revealed that SAPO-44 undergoes modifications in its structure. However, ICP-OES data suggests that Al and/or P are not leached out in the solution indicating that change in local environment around elements is possible. The influence of acid amount, type of acid site etc. on the catalytic activity is discussed and found out that strong acid sites are required to boost the 5-HMF yields.</p>1 aBhaumik, Prasenjit1 aDhepe, Paresh, Laxmikant  uhttps://library.ncl.res.in/content/influence-properties-sapos-one-pot-conversion-mono-di-and-poly-saccharides-5-0