@article { ISI:000236784200028,
	title = {Finite size effects on the structural and magnetic properties of sol-gel synthesized NiFe2O4 powders},
	journal = {Journal of Magnetism and Magnetic Materials},
	volume = {302},
	number = {1},
	year = {2006},
	month = {JUL},
	pages = {190-195},
	publisher = {ELSEVIER SCIENCE BV},
	type = {Article},
	address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS},
	abstract = {<p>Nanoparticles of nickel ferrite have been synthesized by the sol-gel method and the effect of grain size oil its structural and magnetic properties have been Studied in detail. X-ray diffraction (XRD) studies revealed that all the samples are single phasic possessing the inverse spinel structure. Grain size of the sol-gel synthesized powders has been determined from the XRD data and the strain graph. A grain size of 9 nm was observed for the as prepared powders of NiFe2O4 obtained through the sol-gel method. It was also observed that strain was induced during the firing process. Magnetization measurements have been carried out on all the samples prepared in the present series. It was found that the specific magnetization of the nanosized NiFe2O4 powders was lower than that of the corresponding coarse-grained counterparts and decreased with a decrease in grain size. The coercivity of the sol-gel synthesized NiFe2O4 nanoparticles attained a maximum value when the grain size was 15 nm and then decreased as the grain size was increased further. (c) 2005 Elsevier B.V. All rights reserved.</p>},
	keywords = {grain size, magnetic properties, Nanoparticles, Nickel ferrite, strain},
	issn = {0304-8853},
	doi = {10.1016/j.jmmm.2005.08.029},
	author = {George, M. and John, A. M. and Nair, S. S. and Joy, Pattayil Alias and Anantharaman, Maliemadom R.}
}
@article { ISI:000273204100059,
	title = {Flexible microwave absorber based on nickel ferrite nanocomposite},
	journal = {Journal of Alloys and Compounds},
	volume = {489},
	number = {1},
	year = {2010},
	month = {JAN},
	pages = {297-303},
	publisher = {ELSEVIER SCIENCE SA},
	address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND},
	abstract = {<p>Flexible magnetic composite materials were prepared by incorporating precharacterized nickel ferrite nanoparticles in a natural rubber matrix. The complex dielectric permittivity and magnetic permeability of the composites were measured at different microwave frequencies using the cavity perturbation technique. A steady increase in dielectric permittivity was observed with increase in filler concentration. Maxwell-Garnett mixture equations were employed to model the effective permittivity and permeability of the composite. Reflection loss was estimated by employing the model of single layer absorber backed with a perfect conductor. Reflection loss minima of -5.9 dB at 3.2 GHz for 12 mm thick rubber ferrite composite sheet is obtained in the S-band while a loss up to -16 dB could be achieved at 9.5 GHz in the X-band. (C) 2009 Elsevier B.V. All rights reserved.</p>},
	keywords = {Cavity perturbation, Complex permeability, Complex permittivity, Microwave absorber, Nanocomposites, Nickel ferrite},
	issn = {0925-8388},
	doi = {10.1016/j.jallcom.2009.09.077},
	author = {Sunny, Vijutha and Kurian, Philip and Mohanan, P. and Joy, Pattayil Alias and Anantharaman, Maliemadom R.}
}
