@article { ISI:000259765600037,
	title = {Poly(o-anisidine) coatings on brass: synthesis, characterization and corrosion protection},
	journal = {Current Applied Physics},
	volume = {9},
	number = {1},
	year = {2009},
	month = {JAN},
	pages = {206-218},
	publisher = {ELSEVIER SCIENCE BV},
	address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS},
	abstract = {<p>Poly(o-anisidine) (POA) coatings were synthesized on brass by electrochemical polymerization of o-anisidine in aqueous salicylate solution by using cyclic voltammetry. These coatings were characterized by cyclic voltammetry, UV-visible absorption spectroscopy., Fourier transform infrared (FTIR) spectroscopy and scanning electron microscopy (SEM). The corrosion protection aspects of POA coatings on brass in aqueous 3\% NaCl solution were investigated by potentiodynamic polarization technique and electrochemical impedance spectroscopy (EIS). The potentiodynamic polarization measurements show that the POA coating has ability to protect the brass against corrosion. The corrosion potential was about 0.204 V versus SCE more positive for the POA coated brass than that of uncoated brass and reduces the corrosion rate of brass almost by a factor of 800. The corrosion behavior of the POA coatings was also investigated by EIS through immersion tests performed In aqueous 3\% NaCl solution. The evolution of the impedance parameters with the immersion time was studied and the results Show that the POA acts as a protective coating on brass against corrosion in 3\% NaCl solution. The water uptake and delamination area were also determined to further support the corrosion protection performance of the POA coating. (C) 2008 Elsevier B.V. All rights reserved.</p>},
	keywords = {brass, conducting polymers, Corrosion resistant coatings, cyclic voltammetry, Electrochemical impedance spectroscopy, Electrochemical polymerization, poly(o-anisidine)},
	issn = {1567-1739},
	doi = {10.1016/j.cap.2008.01.012},
	author = {Chaudhari, Sudeshna and Gaikwad, A. B. and Patil, P. P.}
}
@article { ISI:000291832600007,
	title = {Enhanced DSSC performance with high surface area thin anatase TiO2 nanoleaves},
	journal = {Solar Energy},
	volume = {85},
	number = {6, SI},
	year = {2011},
	month = {JUN},
	pages = {1213-1219},
	publisher = {PERGAMON-ELSEVIER SCIENCE LTD},
	type = {Article},
	address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, ENGLAND},
	abstract = {<p>Thin anatase TiO2 nanoleaves (NLs) with high surface area (similar to 93 m(2)/g) are synthesized by hydrothermal route and dye-sensitized solar cells (DSSC) made using such NLs are compared with those made with hydro-thermally synthesized TiO2 nanoparticles and the Degussa P25 powder. The NLs-based DSSCs show increment of 16\% and 24\% in the total conversion efficiency over the cells made with NPs and P25 respectively. Interestingly, the highest increment in the conversion efficiency (similar to 35\%) is achieved for cells made using a 50:50 (wt/wt) mixture of NLs and NPs. In this case the dye loading is found to be \&gt;50\% higher than the case of NP films. Moreover the DC resistance of diffusion of I-3(-) in electrolyte (as revealed by the electrochemical impedance spectroscopy) is substantially lower than the NP film case, other cell parameters being nominally comparable. (C) 2011 Elsevier Ltd. All rights reserved.</p>},
	keywords = {Dye-sensitized solar cells, Electrochemical impedance spectroscopy, hydrothermal},
	issn = {0038-092X},
	doi = {10.1016/j.solener.2011.02.029},
	author = {Dhas, Vivek V. and Muduli, Subas and Agarkar, Shruti A. and Rana, Abhimanyu and Hannoyer, Beatrice and Banerjee, Rahul and Ogale, Satishchandra B.}
}
