@article { ISI:000256603500023, title = {Controlled synthesis of ZnO from nanospheres to micro-rods and its gas sensing studies}, journal = {Talanta}, volume = {75}, number = {5}, year = {2008}, month = {JUN}, pages = {1315-1319}, publisher = {ELSEVIER SCIENCE BV}, type = {Article}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

1D ZnO rods are synthesized using less explored hydrazine method. Here we find, besides being combustible hydrazine can also be used as a structure-directing agent. The ratio of zinc nitrate (ZN) to hydrazine is found to control the morphology of ZnO. At lower concentration of ZN as compared with hydrazine the morphology of ZnO is found to be spherical. As we increase the hydrazine content the morphology changes from spherical (diameter similar to 100 nm) to the elongated structures including shapes like Y, T as well dumbbell (diameter similar to 40 nm and length similar to 150 nm). Interestingly for more than 50\% of hydrazine ZnO micro-rods are formed. Such rods are of diameter similar to 120 mn having length of about 1 mu m for ZN to hydrazine ratio of 1:9, isolated as well as bundle of rods are seen in scanning electron microscopy (SEM). The X-ray diffraction (XRD) reveals the phase formation with average particle size of 37 nm as calculated using Scherrer{\textquoteright}s formula. The high-resolution transmission electron microscopy (HRTEM) is also done to confirm the d-spacing in ZnO. Gas sensing study for these samples shows high efficiency and selectivity towards LPG at all operating temperatures. Photoluminescence (PL) study for these samples is performed at room temperature to find potential application as photoelectric material. (C) 2008 Elsevier B.V. All rights reserved.

}, keywords = {Hydrazine, LPG sensor, Nanostructures, photoluminescence, ZnO}, issn = {0039-9140}, doi = {10.1016/j.talanta.2008.01.063}, author = {Navale, Shalaka C. and Gosavi, S. W. and Mulla, Imtiaz S.} } @article { ISI:000256116100044, title = {Influence of Pd doping on morphology and LPG response of SnO2}, journal = {Sensors and Actuators B-Chemical}, volume = {131}, number = {2}, year = {2008}, month = {MAY}, pages = {665-672}, publisher = {ELSEVIER SCIENCE SA}, type = {Article}, address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND}, abstract = {

In the present study nanocrystalline pristine and Pd-doped SnO2 (Pd:SnO2) with various mol\% Pd have been synthesized by a modified Pechini citrate route. Transmission electron microscopy and X-ray powder diffraction studies were used to characterize the morphology, crystallinity, and structure of the SnO2 and Pd:SnO2. The response of the pristine SnO2 and Pd:SnO2 was studied towards different reducing gases. The 1.5 mol\% Pd doping showed an enhanced response of 75 and 95\% towards LPG at as low as 50 and 100 degrees C, respectively, which were quite large high value as compared with pristine SnO2 (38 and 35\% at 50 and 100 degrees C, respectively). Structural characterization revealed that Pd doping reduced the crystallite size of SnO2 and helps in the formation of distinct spherical nanospheres at a calcinations temperature of 500 degrees C. Thus the increase in LPG response can be correlated with the spherical morphology, a decrease in the crystallite size (11 nm) due to doping with Pd as compared with the pristine SnO2 (26 nm) and main role of Pd as a catalyst. (c) 2008 Elsevier B.V. All rights reserved.

}, keywords = {LPG sensor, nanospheres, palladium doping, tin oxide}, issn = {0925-4005}, doi = {10.1016/j.snb.2007.12.055}, author = {Vaishampayan, Mukta V. and Deshmukh, Rupali G. and Mulla, Imtiaz S.} } @article { ISI:000267159700033, title = {Investigations on Ru doped ZnO: strain calculations and gas sensing study}, journal = {Sensors and Actuators B-Chemical}, volume = {139}, number = {2}, year = {2009}, month = {JUN}, pages = {466-470}, publisher = {ELSEVIER SCIENCE SA}, address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND}, abstract = {

Pure and ruthenium (Ru) doped nano-crystalline zinc oxide (ZnO) powders were synthesized by using well-known citrate gel route. Citric acid acts as a chelating agent and thus helps in the formation of nanoparticles. The detailed X-ray diffraction (XRD) studies using Hall equation reveal that in the nanoscale dimensions, incorporation of Ru modulates the lattice strain. It is interesting to note that on Ru doping, the compressive strain present in the undoped ZnO changes into tensile strain. We have tested the response of these specimens individually for reducing gases like H(2), LPG (liquefied petroleum gas), C(2)H(5)OH (ethanol), CO, acetone and oxidizing gases like NO, and Cl(2). Undoped ZnO responses perceptibly to LPG while Ru doped sample highly senses ethanol vapors. This might be due to either change in composition on Ru doping or/and difference between basicity of LPG and C(2)H(5)OH vapors. (C) 2009 Elsevier B.V. All rights reserved.

}, keywords = {Citrate gel, Ethanol sensor, LPG sensor, Nanomaterials, ruthenium}, issn = {0925-4005}, doi = {10.1016/j.snb.2009.03.068}, author = {Navale, Shalaka C. and Ravi, V. and Mulla, Imtiaz S.} } @article { ISI:000272308600054, title = {Influence of palladium on gas-sensing performance of magnesium ferrite nanoparticles}, journal = {Materials Chemistry and Physics}, volume = {119}, number = {1-2}, year = {2010}, month = {JAN}, pages = {319-323}, publisher = {ELSEVIER SCIENCE SA}, address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND}, abstract = {

Commercial ferrites with high densities are mostly used in the electromagnetic devices, which require high temperature synthesis. In this article the gas-sensing characteristics of pure and Pd-doped MgFe(2)O(4) powder has been discussed. The synthesis has been carried out by using a simple molten salt method. This method facilitates rapid synthesis at comparatively lower temperature enabling formation of nanostructures, suitable for the gas-sensing application. Various physicochemical techniques have been used for the characterization of samples. X-ray diffraction analysis confirmed the single-phase formation of pure and Pd-doped MgFe(2)O(4) having crystallite size 15-20 nm. Pure MgFe(2)O(4) showed highest responses towards liquid petroleum gas (LPG) at 350 degrees C while, on doping with Pd the highest response shifted towards lower operating temperature of similar to 200 degrees C. Pure MgFe(2)O(4) exhibited some response towards 200 ppm of LPG which markedly increased on doping of palladium (Pd). The probable mechanism is proposed to explain the selective response towards LPG. (C) 2009 Elsevier B.V. All rights reserved.

}, keywords = {Doping, Ferrite, LPG sensor, Molten salt synthesis, Nanostructures}, issn = {0254-0584}, doi = {10.1016/j.matchemphys.2009.09.004}, author = {Darshane, Sonali L. and Mulla, Imtiaz S.} } @article { ISI:000288877700023, title = {Highly sensitive and selective LPG sensor based on alpha-Fe2O3 nanorods}, journal = {Sensors and Actuators B-Chemical}, volume = {152}, number = {2}, year = {2011}, month = {MAR}, pages = {299-306}, publisher = {ELSEVIER SCIENCE SA}, address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND}, abstract = {

The alpha-Fe2O3 nanorods were successfully synthesized without any templates by calcining the alpha-FeOOH precursor in air at 300 degrees C for 2 h and their LPG sensing characteristics were investigated. The alpha-FeOOH precursor was prepared through a simple and low cost wet chemical route at low temperature (40 degrees C) using FeSO4 center dot 7H(2)O and CH3COONa as starting materials. The formation of alpha-FeOOH precursor and its topotactic transformation to alpha-Fe2O3 upon calcination was confirmed by X-ray diffraction measurement (XRD). X-ray photoelectron spectroscopy (XPS), field emission scanning electron microscopy (FESEM) and transmission electron microscopy (TEM) analysis. The alpha-Fe2O3 nanorods exhibited outstanding gas sensing characteristics such as, higher gas response (similar to 1746-50 ppm LPG at 300 degrees C), extremely rapid response (similar to 3-4 s), relatively slow recovery (similar to 8-9 min), excellent repeatability, good selectivity and lower operating temperature (similar to 300 degrees C). Furthermore, the alpha-Fe2O3 nanorods are able to detect up to 5 ppm for LPG with reasonable response (similar to 15) at the operating temperature of 300 degrees C and they can be reliably used to monitor the concentration of LPG over the range (5-60 ppm). The experimental results clearly demonstrate the potential of using the alpha-Fe2O3 nanorods as sensing material in the fabrication of LPG sensors. Plausible LP G sensing mechanism of the alpha-Fe2O3 nanorods is also discussed. (C) 2010 Elsevier B.V. All rights reserved.

}, keywords = {alpha-Fe2O3 nanorods, FESEM, LPG sensor, Semiconductor gas sensors, TEM, XPS, XRD}, issn = {0925-4005}, doi = {10.1016/j.snb.2010.12.025}, author = {Patil, Dewyani and Patil, Virendra and Patil, Pradip} } @article { ISI:000288189100018, title = {Nanostructured spinet ZnCo2O4 for the detection of LPG}, journal = {Sensors and Actuators B-Chemical}, volume = {152}, number = {1}, year = {2011}, month = {FEB}, pages = {121-129}, publisher = {ELSEVIER SCIENCE SA}, address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND}, abstract = {

Nanostrucutred spinel ZnCo2O4 (similar to 26-30 nm) was synthesized by calcining the mixed precursor (consisting of cobalt hydroxyl carbonate and zinc hydroxyl carbonate) in air at 600 degrees C for 5 h. The mixed precursor was prepared through a low cost and simple co-precipitation/digestion method. The transformation of the mixed precursor into nanostructured spinel ZnCO2O4 upon calcinations was confirmed by X-ray diffraction (XRD) measurement, thermogravimetric analysis (TGA), X-ray photoelectron spectroscopy (XPS) and high resolution transmission electron microscopy (HRTEM). To demonstrate the potential applicability of ZnCo2O4 spinel in the fabrication of gas sensors, its LPG sensing characteristics were systematically investigated. The ZnCo2O4 spinel exhibited outstanding gas sensing characteristics such as, higher gas response (similar to 72-50 ppm LPG gas at 350 degrees C), response time (similar to 85-90 s), recovery time (similar to 75-80 s), excellent repeatability, good selectivity and relatively lower operating temperature (similar to 350 degrees C). The experimental results demonstrated that the nanostructured spinel ZnCo2O4 is a very promising material for the fabrication of LPG sensors with good sensing characteristics. Plausible LPG sensing mechanism is also discussed. (c) 2010 Elsevier B.V. All rights reserved.

}, keywords = {HRTEM, LPG sensor, Nanostructured ZnCo2O4, Semiconductor gas sensors, XPS}, issn = {0925-4005}, doi = {10.1016/j.snb.2010.09.001}, author = {Vijayanand, Subramanian and Joy, Pattayil Alias and Potdar, Hari S. and Patil, Dewyani and Patil, Pradip} } @article { ISI:000305852100053, title = {Influence of Pd-loading on gas sensing characteristics of SnO2 thick films}, journal = {Ceramics International}, volume = {38}, number = {6}, year = {2012}, month = {AUG}, pages = {4835-4844}, publisher = {ELSEVIER SCI LTD}, address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLAND}, abstract = {

Nanocrystalline pristine and 0.5, 1.5 and 3.0 wt\% Pd loaded SnO2 were synthesized by a facile co-precipitation route. These powders were screen-printed on alumina substrates to form thick films to investigate their gas sensing properties. The crystal structure and morphology of different samples were characterized by using X-ray diffraction, scanning electron microscopy and transmission electron microscopy techniques. The 3.0 wt\% Pd:SnO2 showed response of 85\% toward 100 ppm of LPG at operating temperature of 250 degrees C with fast response (8 s) and quick recovery time (24 s). The high response toward LPG on Pd loading can be attributed to lowering of crystallite size (9 nm) as well as the role of Pd particles in exhibiting spill-over mechanism on the SnO2 surface. Also selectivity of 3.0 wt\% Pd:SnO2 toward LPG was confirmed by measuring its response to other reducing gases like acetone (CH3COCH3), ethanol (C2H5OH) and ammonia (NH3) at optimum operating temperature. (C) 2012 Elsevier Ltd and Techna Group S.r.l. All rights reserved.

}, keywords = {LPG sensor, Palladium, SnO2, Thick film}, issn = {0272-8842}, doi = {10.1016/j.ceramint.2012.02.073}, author = {Bagal, L. K. and Patil, J. Y. and Mulla, Imtiaz S. and Suryavanshi, S. S.} }