@article { ISI:000238717900020, title = {Magnetic properties of NiCuZn ferrites synthesized by oxalate precursor method}, journal = {Journal of Magnetism and Magnetic Materials}, volume = {305}, number = {1}, year = {2006}, month = {OCT}, pages = {110-119}, publisher = {ELSEVIER SCIENCE BV}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Ni-Cu-Zn ferrites have been synthesized by employing co-precipitation technique using oxalate precursors. X-ray diffractograms did not show impurity phases, indicating single-phase formation of the ferrites. The diffractograms of oxalate complex decomposed at 650 degrees C show that ferritization is complete up to 650 degrees C. Lattice parameter a (angstrom) was found to decrease with the addition of Ni2+ which is attributed to ionic sizes of Ni2+ (0.69 angstrom), which replaces Cu2+ (0.72 angstrom). From the thermogravimetric studies it is observed that the experimentally observed total mass loss (\%), agrees with theoretically calculated mass loss (\%) indicating maintenance of requisite stoichiometry. Initial permeability (mu(i)) shows increase when Ni2+ is added up to x = 0.15 while for (x \> 0. 15), it decreases. The increase in initial permeability (mu(i)) is attributed to monotonic increase in Ms, and K-1 on addition of Ni2+. However, the microstructure and density (porosity) also influence mu(i) variations. The decrease in pi is attributable to increase of K-1. The composition with density 91.14\% exhibits large mu(i) which also tends to increase with temperature up to 60 degrees C. Thus its usable range extends up to 60 degrees C. This samples has T-c near to 160 degrees C. (c) 2006 Elsevier B.V. All rights reserved.

}, keywords = {initial permeability, magneticproperties, Magnetization, NiCuZn ferrites, XRD}, issn = {0304-8853}, doi = {10.1016/j.jmmm.2005.11.041}, author = {Ghodake, S. A. and Ghodake, U. R. and Sawant, S. R. and Suryavanshi, S. S. and Bakare, P. P.} } @article { ISI:000240831600022, title = {Modifications in magnetic anisotropy of M-type strontium hexaferrite crystals by swift heavy ion irradiation}, journal = {Journal of Magnetism and Magnetic Materials}, volume = {305}, number = {2}, year = {2006}, month = {OCT}, pages = {392-402}, publisher = {ELSEVIER SCIENCE BV}, type = {Article}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Using vibrating sample magnetometery (VSM) 50 MeV Li(3+) ion irradiation effects on magnetic properties of single crystals of SrGa(x)In(y)Fe(12-(x+y))O(19) (where x = 0, 5, 7, 9; y = 0, 0.8, 1.3, 1.0), are reported. The substitution of Ga and In in strontium hexaferrite crystals decreases the value of magnetization sharply, which is attributed to shifting of collinear magnetic order to a non-collinear one. Reduction of magnetization is also explained to be as a result of the occupation of the crystallographic sites of Fe(3+) by Ga(3+) and In(3+). The Li(3+) ion irradiation decreases the value of magnetization, irrespective of whether the crystals are Ga-In substituted or unsubstituted crystals of SrFe(12)O(19). The result is interpreted in terms of the occurrence of a paramagnetic doublet in crystals replacing magnetic sextuplet as a result of irradiation. Substitution of Ga-In in Strontium hexaferrite decreases the value of anisotropy constant. Irradiation with Li(3+) ions increases the values of anisotropy field for both substituted as well as unsubstituted crystals. Substitution with Ga-In also decreases the Curie temperature (T(c)) but the irradiation with Li(3+) ions does not affect the curie temperature of either Ga-In substituted or pure SrFe(12)O(19) crystals. (C) 2006 Elsevier B.V. All rights reserved.

}, keywords = {anisotropy field, Curie temperature, irradiation, Magnetic anisotropy, Magnetization}, issn = {0304-8853}, doi = {10.1016/j.jmmm.2006.01.110}, author = {Kaur, Balwinder and Bhat, Monita and Licci, F. and Kumar, Ravi and Kulkarni, S. D. and Joy, Pattayil Alias and Bamzai, K. K. and Kotru, P. N.} } @article { ISI:000268022700058, title = {Magnetic and dielectric properties of nanophase manganese-substituted lithium ferrite}, journal = {Journal of Magnetism and Magnetic Materials}, volume = {321}, number = {19}, year = {2009}, month = {OCT}, pages = {3270-3273}, publisher = {ELSEVIER SCIENCE BV}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Nanocrystalline manganese-substituted lithium ferrites viz. Li0.5Fe2.5-xMnxO4 (2.5 \<= x \>= 0) were prepared by sol-gel autocombustion method. X-ray diffraction analysis confirmed that as the concentration of manganese increases the cubic phase changes to the tetragonal phase. The variation of saturation magnetization was studied as a function of manganese content. All the compositions indicate that they are ferrimagnetic in nature. The dielectric constant, dielectric loss tangent and ac conductivity of all samples were measured at room temperature as a function of frequency. These parameters decrease with increase in frequency for all of the samples. The substitution of manganese plays an important role in changing the structural and magnetic properties of these ferrites. The compositional variation of dielectric constant and d.c. resistivity shows an inverse trend of variation with each other. (C) 2009 Elsevier B.V. All rights reserved.

}, keywords = {dielectric constant, Ferrite, Magnetization, X-ray diffraction}, issn = {0304-8853}, doi = {10.1016/j.jmmm.2009.05.074}, author = {Hankare, P. P. and Patil, R. P. and Sankpal, U. B. and Jadhav, S. D. and Mulla, Imtiaz S. and Jadhav, K. M. and Chougule, B. K.} } @article { ISI:000288772300011, title = {Magnetic properties of thermal plasma synthesized nanocrystalline nickel ferrite (NiFe2O4)}, journal = {Journal of Alloys and Compounds}, volume = {509}, number = {12}, year = {2011}, month = {MAR}, pages = {4404-4413}, publisher = {ELSEVIER SCIENCE SA}, address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND}, abstract = {

A rapid synthesis method is reported for magnetic nanoparticles of nickel ferrite involving thermal plasma assisted vapor phase condensation process. The as-synthesized samples were characterized by X-ray Diffraction, Transmission Electron Microscopy, Vibrating Sample Magnetometer and X-ray Photoelectron Spectroscopy techniques. The average particle size was determined from the TEM micrographs and found to be around 30 nm. The effects of reactor parameters on the magnetic and structural properties have been evaluated, to find the optimized parameters so as to achieve the highest values of saturation magnetization and coercivity. Reasonably high saturation magnetization (48 emu/g) has been assigned to the high degree of crystallinity, achieved on account of high temperature during the growth, and the cation redistribution. The high value of coercivity (1150e) is explained on the basis of possible lattice defects arising from the cation redistribution. Detailed analysis of cation distribution using the XRD line intensity data leads to the conclusion that these samples are iron deficit and nickel rich. (C) 2011 Elsevier B.V. All rights reserved.

}, keywords = {crystal structure, Magnetic measurements, Magnetization, Nanostructured materials, TEM}, issn = {0925-8388}, doi = {10.1016/j.jallcom.2011.01.057}, author = {Nawale, Ashok B. and Kanhe, Nilesh S. and Patil, K. R. and Bhoraskar, S. V. and Mathe, Vikas L. and Das, A. K.} } @article { ISI:000311219900028, title = {Effect of cation distribution on structural and magnetic properties of Dy substituted magnesium ferrite}, journal = {Journal of Magnetism and Magnetic Materials}, volume = {327}, year = {2013}, month = {FEB}, pages = {159-166}, publisher = {ELSEVIER SCIENCE BV}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Magnesium ferrite and dysprosium (Dy3+) substituted with composition MgDyxFe2-xO4 (x = 0.00-0.07) was prepared by solid state reaction technique. Spinel phase formation was identified using x-ray diffraction technique, thus establishing the cubic spinel symmetry. The morphology was seen through scanning electron microscopic technique, from where the grain size was calculated using average intercept line method. The elemental composition of pure and dysprosium substituted magnesium ferrite was calculated from energy dispersive x-ray analysis spectrum which is then correlated with the experimentally obtained values. Magnetic hysteresis loop of the various compositions establishes it to be soft ferrimagnetic material. The magnetic parameters such as saturation magnetization, coercivity, and retentivity were also calculated. Temperature dependence of saturation magnetization was done to find the Curie temperature of different compositions. (c) 2012 Elsevier B.V. All rights reserved.

}, keywords = {Cation distribution, Curie temperature, Electron microscopy, Magnetization, Spinel ferrite}, issn = {0304-8853}, doi = {10.1016/j.jmmm.2012.09.013}, author = {Bamzai, K. K. and Kour, Gurbinder and Kaur, Balwinder and Kulkarni, S. D.} }