@article { ISI:000226532100001, title = {Synthesis, characterization and photo catalytic degradation of aqueous eosin over Cr containing Ti/MCM-41 and SiO2-TiO2 catalysts using visible light}, journal = {Journal of Molecular Catalysis A - Chemical}, volume = {226}, number = {2}, year = {2005}, month = {FEB}, pages = {149-154}, publisher = {ELSEVIER SCIENCE BV}, type = {Article}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Two series of samples were prepared namely Cr-Ti/MCM-41 and Cr/SiO2-TiO2 keeping Si/Ti mole ratio same, with different Cr loading. The physico-chemical properties of the samples were characterized by different analytical techniques such as XRD, FTIR, TEM, low temperature N-2 sorption, and UV-vis diffused reflectance spectroscopy. The impregnated TiO2 was in anatase form. The crystallite size was determined from Scherrer equation as well as by TEM. There is a difference between the shapes of nitrogen adsorption isotherms with and without Cr-loaded Ti/MCM-41 samples. The rate of nitrogen adsorption was found to increase with decrease in Cr content at lower P/P-0 for Cr-Ti/MCM-41 samples due to the blocking of the pores with Cr. All MCM-41 samples exhibited pore sizes from 24 nm to 32 nm. UV-vis diffused reflectance spectra of all Cr-loaded samples showed red shift of their absorption edges. Photo degradation of eosin dye was studied using visible light. (C) 2004 Elsevier B.V. All rights reserved.

}, keywords = {Cr-Ti/MCM-41, Cr/SiO2-TiO2, eosin, photo degradation, visible light}, issn = {1381-1169}, doi = {10.1016/j.molcata.2004.09.055}, author = {Awate, S. V. and Jacob, Nalini E. and Deshpande, Suvarna S. and Gaydhankar, T. R. and Belhekar, Anagha A.} } @article { ISI:000314381700030, title = {One-pot synthesis of gold nanoparticle/molybdenum cluster/graphene oxide nanocomposite and its photocatalytic activity}, journal = {Applied Catalysis B-Environmental}, volume = {130}, year = {2013}, month = {FEB}, pages = {270-276}, publisher = {ELSEVIER SCIENCE BV}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

The paper reports on a facile one-pot synthesis of a tri-component gold nanoparticle/molybdenum cluster/graphene oxide (AuNPs@Mo-GO) nanohybrid composite. The synthetic methodology consists on direct UV irradiation of an aqueous solution containing graphene oxide (GO), Na-2[Mo6Br8(N-3)(6)], HAuCl4 center dot 3H(2)O and isopropanol at room temperature in air using a UV fiber lamp. The composite material exhibits very high photocatalytic activity for the degradation of rhodamine B under visible light irradation. The resulting nanohybrid material was characterized using Raman spectroscopy, UV-vis spectrometry, transmission electron microscopy (TEM) and X-ray photoelectron spectroscopy (XPS). (c) 2012 Elsevier B.V. All rights reserved.

}, keywords = {gold nanoparticles, graphene oxide, Nanohybrid, Photodegradation, Rhodamine B, visible light, [Mo6Br8(N-3)(6)](2-)cluster}, issn = {0926-3373}, doi = {10.1016/j.apcatb.2012.11.017}, author = {Barras, Alexandre and Das, Manash R. and Devarapalli, Rami Reddy and Shelke, Manjusha V. and Cordier, Stephane and Szunerits, Sabine and Boukherroub, Rabah} } @article { ISI:000350842300005, title = {Recent developments in solar H-2 generation from water splitting}, journal = {Journal of Chemical Sciences}, volume = {127}, number = {1}, year = {2015}, month = {JAN}, pages = {33-47}, publisher = {INDIAN ACAD SCIENCES}, address = {C V RAMAN AVENUE, SADASHIVANAGAR, P B \#8005, BANGALORE 560 080, INDIA}, abstract = {

Hydrogen production from water and sunlight through photocatalysis could become one of the channels, in the not-so-distant future, to meet a part of ever growing energy demands. However, accomplishing solar water splitting through semiconductor particulate photocatalysis seems to be the {\textquoteleft}Holy Grail{\textquoteright} problem of science. In the present mini-review, some of the critical strategies of semiconductor photocatalysis are focused with the aim of enumerating underlying critical factors such as visible light harvesting, charge carrier separation, conduction and their utilization that determine the quantum efficiency. We attempted to bring out the essential requirements expected in a material for facile water splitting by explaining important and new designs contributed in the last decade. The newly emerged designs in semiconductor architecture employing nanoscience towards meeting the critical factors of facile photocatalysis are elucidated. The importance of band gap engineering is emphasized to utilize potential wide band gap semiconductors. Assistance of metal nanostructures and quantum dots to semiconductors attains vital importance as they are exuberant visible light harvesters and charge carrier amplifiers. Benevolent use of quantum dots in solar water splitting and photoelectrochemical water splitting provides scope to revolutionize the quantum efficiency by its multiple exciton generation features. A list of drawbacks and issues that hamper the much needed breakthrough in photocatalysis of water splitting is provided to invite attention to address them and move towards sustainable water splitting.

}, keywords = {Hydrogen, nanomaterial, Photocatalysis, quantum dot, Semiconductor, visible light, water splitting}, issn = {0974-3626}, doi = {10.1007/s12039-014-0747-0}, author = {Rajaambal, Sivaraman and Sivaranjani, Kumarsrinivasan and Gopinath, Chinnakonda S.} } @article { ISI:000372684900009, title = {Photocatalytic H-2 evolution from water-methanol mixtures on InGaO3(ZnO)(m) with an anisotropic layered structure modified with CuO and NiO cocatalysts}, journal = {Journal of Molecular Catalysis A-Chemical}, volume = {415}, year = {2016}, month = {MAY}, pages = {82-88}, publisher = {ELSEVIER SCIENCE BV}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

InGaO3(ZnO)(m) series of oxides is found to be active for photocatalytic H-2 evolution from water-methanol mixtures. The structure of this series is highly anisotropic with InO6 octahedral layers sandwiching Ga/ZnOn polyhedra. The structural anisotropy in which the conducting layer is spatially separated from the charge generation sites may help in suppressing charge recombination and consequently enhance catalytic activity. The band gaps of the series obtained from absorption spectra are above 3.6 eV and hence they are not active under visible light irradiation. H-2 evolution is considerably enhanced under UV light on employing NiO as cocatalyst due to facile electron transfer from InGaO3(ZnO)(m). to NiO. However, when CuO is used as cocatalyst, visible light activity could be brought out. Due to the very low band gap of CuO, it can act as a sensitizer absorbing in visible light. The band positions become conducive for H-2 evolution due to band alignments consequent to electron accumulation in CuO conduction band. (C) 2016 Elsevier B.V. All rights reserved.

}, keywords = {InGaO3(ZnO)(m), photocatalytic water splitting, visible light, XPS, XRD}, issn = {1381-1169}, doi = {10.1016/j.molcata.2016.01.018}, author = {Narendranath, Soumya B. and Thekkeparambil, Saranya V. and George, Leena and Thundiyil, Shibin and Devi, R. Nandini} } @article { ISI:000372156200013, title = {Synthesis of Sn-containing anatase (TiO2) by sol-gel method and their performance in catalytic water splitting under visible light as a function of tin content}, journal = {Materials Letters}, volume = {171}, year = {2016}, month = {MAY}, pages = {50-54}, publisher = {ELSEVIER SCIENCE BV}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Sol-gel route was employed to prepare a series of Sn-containing anatase with different molar (Ti/Sn) ratios ranging from 49 to 1. Samples were characterized by powder XRD, UV-vis, XPS, SEM, EDAX, low temperature N-2 sorption technique and Raman Spectroscopy. Except anatase phase, no other crystalline phase was observed when Ti/Sn molar ratio was varied from 49 to 9 and for Sn free sample. However, further decrease in the ratio lead to the appearance of additional SnO2 phase whose peak intensities were increased with the increase in the tin content. Irrespective of tin content, all samples showed red-shift in UV-vis spectra. Moreover, samples showed Raman shift to higher vibration side from 143 cm(-1) to 147 cm(-1) indicating the doping of Sn2+ into TiO2. By virtue of low band gap, anatase crystallite size and an absence of XRD visible SnO2, ST (19) has shown maximum photocatalytic activity upon 1 wt\% Pt loading. It has exhibited the highest rate (0.1264 mmole/g/h) for visible light induced hydrogen evolution by water splitting. (C) 2016 Elsevier B.V. All rights reserved.

}, keywords = {Semiconductors, Sn2+ doped titania, SnO2/TiO2, Sol-gel preparation, visible light, water splitting}, issn = {0167-577X}, doi = {10.1016/j.matlet.2016.02.055}, author = {Tangale, N. P. and Niphadkar, P. S. and Samuel, V. and Deshpande, Suvarna S. and Joshi, P. N. and Awate, S. V.} }