@article { ISI:000230160700011, title = {Coprecipitation technique to prepare SrNb2O6}, journal = {Materials Characterization}, volume = {55}, number = {1}, year = {2005}, month = {JUL}, pages = {92-95}, publisher = {ELSEVIER SCIENCE INC}, type = {Article}, address = {360 PARK AVE SOUTH, NEW YORK, NY 10010-1710 USA}, abstract = {

A mixture of ammonium oxalate and ammonium hydroxide was used to co-precipitate strontium and niobium ions as strontium oxalate and niobium hydroxide under basic conditions. This precursor yielded SrNb2O6 ceramics on calcining at 650 degrees C. This is a much lower temperature compared to preparation of SrNb2O6 by the traditional solid state method (900 degrees C). Transmission electron microscopy (TEM) revealed that the average particle size is 100 nm for the calcined powders. The room temperature dielectric constant at 1 kHz is found to be 550. The ferroelectric hysteresis loop parameters of these samples were also studied. (c) 2005 Elsevier Inc. All rights reserved.

}, keywords = {Ceramics, Electron microscopy, ferroelectric, Oxides, X-ray methods}, issn = {1044-5803}, doi = {10.1016/j.matchar.2005.04.002}, author = {Ravi, V} } @article { ISI:000228794300014, title = {Preparation of fine MgTa2O6 and Mg4Ta2O9 powders by chemical methods}, journal = {Materials Science and Engineering B-Solid State Materials for Advanced Technology}, volume = {119}, number = {2}, year = {2005}, month = {MAY}, pages = {189-191}, publisher = {ELSEVIER SCIENCE SA}, type = {Article}, address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND}, abstract = {

Two different chemical methods are applied to prepare MgTa2O6 (MT2) and Mg4Ta2O9 (M4T2) powders. A gel was formed when a aqueous solution of Mg(NO3)(2), TAF(5) and citric acid in stoichiometric ratio is heated on a water bath. This gel on decomposition at 750 degrees C produced the fine crystallites of ternary oxide, M4T2. A simple co-precipitation technique had been successfully applied for the preparation of pure ultrafine single phase MT2. Ammonium hydroxide was used to precipitate Mg2+ and Ta5+ cations as hydroxides simultaneously. This precursor on heating at 750 degrees produces MT2 powders. The phase contents and lattice parameters were studied by the powder X-ray diffraction (XRD). Particle size and morphology was studied by transmission electron microscopy (TEM). (c) 2005 Elsevier B.V. All rights reserved.

}, keywords = {Electron microscopy, powders-chemical preparation, X-ray methods}, issn = {0921-5107}, doi = {10.1016/j.mseb.2005.02.058}, author = {Navale, SC and Ravi, V} } @article { ISI:000228771600009, title = {Synthesis of nanocrystalline rutile}, journal = {Ceramics International}, volume = {31}, number = {4}, year = {2005}, month = {JAN}, pages = {555-557}, publisher = {ELSEVIER SCI LTD}, type = {Article}, address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLAND}, abstract = {

Nanocrystalline titanium dioxide (TiO2) in the rutile phase has been obtained by homogeneous precipitation using urea and TiOCl2. A mixture of urea and TiOCl2 is heated on a hot water bath at 65-75 degrees C to precipitate rutile powders. X-ray diffraction (XRD) studies on these oven-dried powders indicated the formation of single-phase rutile. Raman scattering experiments were also performed to confirm the formation of the rutile phase. Transmission electron microscopy (TEM) investigations revealed the average particle size of these powders to be 40 nm. (c) 2004 Elsevier Ltd and Techna Group S.r.l. All rights reserved.

}, keywords = {chemical preparation, Electron microscopy, powders, TiO2, X-ray methods}, issn = {0272-8842}, author = {Samuel, V and Pasricha, R and Ravi, V} } @article { ISI:000237439300005, title = {Coprecipitation technique to prepare NaNbO3 and NaTaO3}, journal = {Bulletin of Materials Science}, volume = {29}, number = {2}, year = {2006}, month = {APR}, pages = {123-125}, publisher = {INDIAN ACADEMY SCIENCES}, type = {Article}, address = {C V RAMAN AVENUE, SADASHIVANAGAR, P B \#8005, BANGALORE 560 080, INDIA}, abstract = {

A simple coprecipitation technique has been used successfully for the preparation of pure, ultrafine, single phases of NaNbO3 (NN) and NaTaO3 (NT). An alcoholic solution of ammonium carbonate and ammonium hydroxide was used to precipitate Na+ and Nb5+ (or Ta5+) cations under basic conditions as carbonate and hydroxide, respectively. On heating at 700 degrees C, these precursors produce respective products. For comparison, both NN and NT powders were also prepared by the traditional solid state method. The phase purity and lattice parameters were studied by powder X-ray diffraction (XRD). The particle size and morphology were studied by scanning electron microscopy (SEM).

}, keywords = {Ceramics, Chemical synthesis, Electron microscopy, electronic materials, Oxides, X-ray methods}, issn = {0250-4707}, doi = {10.1007/BF02704604}, author = {Samuel, V and Gaikwad, A. B. and Ravi, V} }