@conference {42804,
	title = {Poly(High Internal Phase Emulsion) of 2-EHA, 2-EHMA and EGDA with naturally occurring phenolic compounds", paper presented at international conference on ?polymers for advanced technology},
	booktitle = {Polymers for Advanced Technology},
	year = {2006},
	month = {DEC},
	address = {National Chemical Laboratory, Pune},
	author = {Ingavle, Ganesh C. and Shaikh, A. A. and Bhongale, Sunil Sitaram and Scaria, S. and Chavan, Nayaku and Qureshi, Mohammed and Ponrathnam, Surendra}
}
@article { ISI:000265814500012,
	title = {Polypyrrole functionalized with ferrocenyl derivative as a rapid carbon monoxide sensor},
	journal = {Synthetic Metals},
	volume = {159},
	number = {5-6},
	year = {2009},
	month = {MAR},
	pages = {415-418},
	publisher = {ELSEVIER SCIENCE SA},
	address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND},
	abstract = {<p>A rapid carbon monoxide detection system was developed with the electrochemical functioncalization of polypyrrole (PPy) with ferrocenylmethyltrimethylammonium iodide (FTMA-I) as a co-dopant exhibits very high sensitivity to ppm levels of carbon monoxide gas and fast recovery under normal dry room temperature conditions. The co-dopant was synthesized mainly to incorporate into PPy electrochemically to modify the properties in order to sense carbon monoxide (CO) gas. The FTMA-I doped PPy exhibited the characteristics oxidation/reduction peaks for ferrocene in its cyclic voltammograms. The modified PPy films deposited on interdigited electrodes gave rapid sensitivity within a second to 300 ppm carbon monoxide gas and good sensitivity factor was observed even at 4 mmol of the functional groups in the polymer for 300 ppm carbon monoxide gas. This material detected the CO gas concentration as low as 100 ppm. (C) 2008 Elsevier B.V. All rights reserved.</p>},
	keywords = {carbon monoxide, Chemical sensor, conducting polymer, polypyrrole},
	issn = {0379-6779},
	doi = {10.1016/j.synthmet.2008.10.013},
	author = {Paul, Santhosh and Chavan, Nayaku and Radhakrishnan, S.}
}
@article { ISI:000300929600025,
	title = {Photopolymerization kinetics of 2-phenylethyl (meth) acrylates studied by photo DSC},
	journal = {Journal of Polymer Research},
	volume = {19},
	number = {2},
	year = {2012},
	month = {JAN},
	pages = {9811},
	publisher = {SPRINGER},
	address = {VAN GODEWIJCKSTRAAT 30, 3311 GZ DORDRECHT, NETHERLANDS},
	abstract = {<p>The present work deals with the photopolymerization of 2-phenylethyl (meth)acrylates and estimation of their kinetic parameters. Formulations were made by independently homogenizing the monomers with photoinitiators of two different classes. Two different compositions of photoinitiators were used to study the effect of concentration of photoinitiator on cure kinetics. These compositions obtained were tested for photo curing performance using differential photocalorimetry (DPC) or photo DSC under polychromatic radiation. The heat flow against time was recorded for all formulations under isothermal conditions and the rates of polymerization as well as the percentage conversions were estimated. It was observed that due to a longer timescale for reaction diffusion, the methacrylate formulations showed a higher conversion than acrylate formulations. Other parameters such as induction time, maximum rate and conversion attained as well as the time to attain peak maximum were noted. The photopolymerization and kinetic estimations of the formulations including evaluation of kinetic models are discussed.</p>},
	keywords = {Bimolecular termination model, Photo DSC, Photopolymerization, Variable autocatalytic model},
	issn = {1022-9760},
	doi = {10.1007/s10965-011-9811-3},
	author = {Ghorpade, Ravindra V. and Bhosle, Sonali Madhavrao and Ponrathnam, S. and Rajan, C. R. and Chavan, Nayaku and Harikrishna, Reghunathan}
}
