@article { ISI:000235860500029,
	title = {Chemical methods to synthesize FeTiO3 powders},
	journal = {Materials Letters},
	volume = {60},
	number = {11},
	year = {2006},
	month = {MAY},
	pages = {1425-1427},
	publisher = {ELSEVIER SCIENCE BV},
	type = {Article},
	address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS},
	abstract = {<p>Three different techniques were used to synthesize FeTiO3 powders. The first method is simple coprecipitation of both Fe and Ti ions under basic conditions using standard ammonia solution from aqueous ferric nitrate and titanium oxy chloride. This precipitate on heating at 400 degrees C produces ilmenite phase. The second method is to digest hydroxide precipitates at 100 degrees C to form FeTiO3 phase. The third technique is to make use of citrate process to form FeTiO3 powders. The phase contents and lattice parameters were Studied by powder X-ray diffraction (XRD). Particle size and morphology were studied by Transmission Electron Microscopy (TEM). (c) 2005 Elsevier B.V. All tights reserved.</p>},
	keywords = {Chemical synthesis, Electron microscopy, electronic materials, X-ray methods},
	issn = {0167-577X},
	doi = {10.1016/j.matlet.2005.11.041},
	author = {Mona, J. and Kale, Sangeeta N. and Gaikwad, A. B. and Murugan, A. Vadivel and Ravi, V.}
}
@article { ISI:000246260000011,
	title = {Preparation of nanocrystalline ferroelectric CaBi4Ti4O15 by citrate gel method},
	journal = {Ceramics International},
	volume = {33},
	number = {4},
	year = {2007},
	month = {JAN},
	pages = {569-571},
	publisher = {ELSEVIER SCI LTD},
	type = {Article},
	address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLAND},
	abstract = {<p>A gel was formed when an aqueous solution of CaCl2, BiNO3, TiOCl2 and citric acid in stoichiometric ratio is heated on a water bath. This gel on decomposition at 700 degrees C produced nano crystallites of the ternary oxide, CaBi4Ti4O15 (CBT). The phase contents and lattice parameters were studied by the powder X-ray diffraction (XRD). Particle size and morphology was studied by transmission electron spectroscopy (TEM). The room temperature dielectric constant at 1 kHz is 390. The ferroelectric hysteresis loop parameters of these samples were also studied by a home-built Sawyer-tower circuit. (c) 2006 Elsevier Ltd and Techna Group S.H. All rights reserved.</p>},
	keywords = {Ceramics, Chemical synthesis, Electron microscopy, Oxides, X-ray methods},
	issn = {0272-8842},
	doi = {10.1016/j.ceramint.2005.11.006},
	author = {Murugan, A. Vadivel and Gaikwad, A. B. and Samuel, V. and Ravi, V.}
}
