@article { ISI:000235860500029, title = {Chemical methods to synthesize FeTiO3 powders}, journal = {Materials Letters}, volume = {60}, number = {11}, year = {2006}, month = {MAY}, pages = {1425-1427}, publisher = {ELSEVIER SCIENCE BV}, type = {Article}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Three different techniques were used to synthesize FeTiO3 powders. The first method is simple coprecipitation of both Fe and Ti ions under basic conditions using standard ammonia solution from aqueous ferric nitrate and titanium oxy chloride. This precipitate on heating at 400 degrees C produces ilmenite phase. The second method is to digest hydroxide precipitates at 100 degrees C to form FeTiO3 phase. The third technique is to make use of citrate process to form FeTiO3 powders. The phase contents and lattice parameters were Studied by powder X-ray diffraction (XRD). Particle size and morphology were studied by Transmission Electron Microscopy (TEM). (c) 2005 Elsevier B.V. All tights reserved.

}, keywords = {Chemical synthesis, Electron microscopy, electronic materials, X-ray methods}, issn = {0167-577X}, doi = {10.1016/j.matlet.2005.11.041}, author = {Mona, J. and Kale, Sangeeta N. and Gaikwad, A. B. and Murugan, A. Vadivel and Ravi, V.} } @article { ISI:000238866300004, title = {Coprecipitation technique to prepare Sr0.5Ba0.5Nb2O6}, journal = {Bulletin of Materials Science}, volume = {29}, number = {3}, year = {2006}, month = {JUN}, pages = {221-223}, publisher = {INDIAN ACADEMY SCIENCES}, type = {Article}, address = {C V RAMAN AVENUE, SADASHIVANAGAR, P B \#8005, BANGALORE 560 080, INDIA}, abstract = {

An aqueous mixture of ammonium oxalate and ammonium hydroxide was used to coprecipitate barium and strontium ions as oxalates and niobium ions as hydroxide under basic conditions. This precursor on calcining at 750 degrees C yielded Sr0.5Ba0.5Nb2O6 phase. This is a much lower temperature than that prepared by traditional solid state method (1000 degrees C) as reported for the formation of Sr0.5Ba0.5Nb2O6 (SBN). Transmission electron microscopic (TEM) investigations revealed that the average particle size was 80 nm for the calcined powders. The room temperature dielectric constant at I kHz was found to be 1100. The ferroelectric hysteresis loop parameters of these samples were also studied.

}, keywords = {Ceramics, Electron microscopy, ferroelectricity, Oxides, X-ray diffraction}, issn = {0250-4707}, doi = {10.1007/BF02706488}, author = {Murugan, A. Vadivel and Gaikwad, A. B. and Samuel, V. and Ravi, V.} } @article { ISI:000237158200003, title = {Phase evolution of NiTiO3 prepared by coprecipitation method}, journal = {Materials Letters}, volume = {60}, number = {15}, year = {2006}, month = {JUL}, pages = {1791-1792}, publisher = {ELSEVIER SCIENCE BV}, type = {Article}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

A simple coprecipitation technique was used for the preparation of NiTiO3 powders. Ammonium carbonate solution was added to a solution mixture containing stoichiometric amounts of Ni(NO3)(2) and TiOCl2 to precipitate nickel as carbonate and titanium as hydroxide under basic conditions. The precipitate was calcined at different temperatures ranging from 100 to 800 degrees C and phase evolution of NiTiO3 was investigated by X-ray diffraction (XRD) studies. It is observed that nickel titanate was formed at 750 degrees C. For comparison, NiTiO3 was also prepared by standard ceramic process. Particle size and morphology was studied by transmission electron microscopy (TEM). (c) 2005 Elsevier B.V. All fights reserved.

}, keywords = {Ceramics, Chemical synthesis, Electron microscopy, NiTiO3, Oxides, X-ray diffraction}, issn = {0167-577X}, doi = {10.1016/j.matlet.2005.12.023}, author = {Murugan, A. Vadivel and Samuel, V. and Navale, S. C. and Ravi, V.} } @article { ISI:000234951400008, title = {Preparation of nanocrystalline ferroelectric BaBi4Ti4O15 by Pechini method}, journal = {Materials Letters}, volume = {60}, number = {8}, year = {2006}, month = {APR}, pages = {1023-1025}, publisher = {ELSEVIER SCIENCE BV}, type = {Article}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

A gel was formed when an aqueous solution of BaCl2, BiNO3, TiOCl2 and citric acid in stoichiometric ratio is heated on a water bath. This gel on decomposition at 600 degrees C produced the nano crystallites of ternary oxide, BaBi4Ti4O15 (BBT). The phase contents and lattice parameters were Studied by the powder X-ray diffraction (XRD). Particle size and morphology was studied by transmission electron spectroscopy (TEM). The room temperature dielectric constant at I KHz is 90. The ferroelectric hysteresis loop parameters of these samples were also studied by a home built Sawyer-tower circuit. (c) 2005 Elsevier B.V. All rights reserved.

}, keywords = {dielectric properties, Electron microscopy, ferroelectric properties, powders chemical preparation}, issn = {0167-577X}, doi = {10.1016/j.matlet.2005.10.068}, author = {Murugan, A. Vadivel and Navale, S. C. and Ravi, V.} } @article { ISI:000246260000011, title = {Preparation of nanocrystalline ferroelectric CaBi4Ti4O15 by citrate gel method}, journal = {Ceramics International}, volume = {33}, number = {4}, year = {2007}, month = {JAN}, pages = {569-571}, publisher = {ELSEVIER SCI LTD}, type = {Article}, address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLAND}, abstract = {

A gel was formed when an aqueous solution of CaCl2, BiNO3, TiOCl2 and citric acid in stoichiometric ratio is heated on a water bath. This gel on decomposition at 700 degrees C produced nano crystallites of the ternary oxide, CaBi4Ti4O15 (CBT). The phase contents and lattice parameters were studied by the powder X-ray diffraction (XRD). Particle size and morphology was studied by transmission electron spectroscopy (TEM). The room temperature dielectric constant at 1 kHz is 390. The ferroelectric hysteresis loop parameters of these samples were also studied by a home-built Sawyer-tower circuit. (c) 2006 Elsevier Ltd and Techna Group S.H. All rights reserved.

}, keywords = {Ceramics, Chemical synthesis, Electron microscopy, Oxides, X-ray methods}, issn = {0272-8842}, doi = {10.1016/j.ceramint.2005.11.006}, author = {Murugan, A. Vadivel and Gaikwad, A. B. and Samuel, V. and Ravi, V.} }