@article {47600,
	title = {Aqueous methanol to formaldehyde and hydrogen on Pd/TiO2 by photocatalysis in direct sunlight: structure dependent activity of nano-Pd and atomic Pt-coated counterparts},
	journal = {ACS Applied Energy Materials},
	volume = {4},
	year = {2021},
	month = {NOV },
	pages = {13347-13360},
	type = {Article},
	abstract = {In the present investigation, facet-controlled Pd nanoparticles with nanocube (Pd-NC) and truncated octahedron (Pd-TO) morphologies, and their counterparts with half-a-monolayer of atomic Pt coated (0.5 theta(Pt)-Pd-NC and 0.5 theta(Pt)-Pd-TO) surfaces were prepared. All of them were characterized and evaluated as cocatalyst after supporting them on commercial titania (P25) (Pd-NC/P25, Pd-TO/P25, 0.5 theta(Pt)-Pd-NC/P25, and 0.5 theta(Pt)-Pd-TO/P25) under direct sunlight and/or one sun conditions for the oxidation of methanol to formaldehyde along with solar hydrogen production. Pd-NC/P25 shows higher activity for hydrogen generation compared to Pd-TO/P25; however, activity reversal occurs with the above cocatalysts, but, after Pt-coating with further enhanced activity. The highest conversion of methanol (0.2 mu mol/h.mg) to 100\% selective formaldehyde was observed with 0.5 theta(Pt)-Pd-TO/P25, while other catalysts show significantly lower methanol conversion in the following order: 0.5 theta(Pt)-Pd-TO/P25 > 0.5 theta(Pt)-Pd-NC/P25 > Pd-NC/P25 > Pd-TO/P25. Pt-coated on (111) facets of Pd-TO simulates the activity associated as that of Pt(111) facets and demonstrating the highest and facet dependent activity. The present study is truly in resonance with exploiting the surface properties for heterogeneous catalysis, and highlights that less than a monolayer of Pt is sufficient to simulate the activity as that of bulk Pt. It is worth exploring this concept to other metals and substrates too.},
	keywords = {heterogeneous catalysis, Nanomaterials, Oxidation, Photocatalysis, surface modification},
	issn = {2574-0962},
	doi = {10.1021/acsaem.1c03080},
	author = {Nalajala, Naresh and Salgaonkar, Kranti N. and Chauhan, Inderjeet and Mekala, Siva Prasad and Gopinath, Chinnakonda S.}
}
@article {48273,
	title = {Selective and generic photocatalytic oxidation of alcohol with Pd-TiO2 thin films: butanols to butanal/butanone with different morphologies of Pd and 0.5 theta(Pt)-Pd counterparts},
	journal = {Chemistry-An Asian Journal},
	volume = {18},
	year = {2023},
	month = {MAR},
	type = {Article},
	abstract = {<p>The present study reports on the photocatalytic oxidation of butanols to butanal/butanone using thin film form of facet-dependent nano-Pd supported on commercial TiO2 under one-sun condition and demonstrates the generic nature. Pd-nanocube (Pd-NC(100)), Pd-truncated octahedron (Pd-TO (100) and (111)), polycrystalline (Pd-PC), and their counterparts with half-a-monolayer Pt-coated on Pd (0.5 theta(Pt)-Pd)) have been used as co-catalyst. A potentially scalable thin film form of Pd/TiO2 photocatalyst, prepared by drop-casting method, has been employed to study oxidation of n-butanol, 2-butanol, and iso-butanol to corresponding aldehyde/ketone. 100\% selectivity is demonstrated to respective aldehyde/ketone with any catalyst used in the present study with varying degree of butanols conversion by NMR. 0.5 theta(Pt)-Pd-TO/TiO2 shows the highest conversion of 2-butanol to butanone (13.6\% in 4 h). Continuous 10 h of reaction with the most active 0.5 theta(Pt)-Pd-TO/P25 catalyst demonstrates 31\% conversion of 2-butanol to butanone, and catalyst recyclability has been demonstrated. The present protocol can be scalable to large scales to maximize the conversion in direct sunlight. Due to its generic nature, the current method can also be applied to many other alcohols and substrate molecules.</p>
},
	keywords = {energy conversion, Nanomaterials, Oxidation, Photocatalysis, Sustainability},
	issn = {1861-4728},
	doi = {10.1002/asia.202201239},
	author = {Salgaonkar, Kranti N. and Kale, Sandip R. and Nalajala, Naresh and Mansuri, Sayana and Gopinath, Chinnakonda S.}
}
