@article { ISI:000241849900010,
	title = {Novel chemical synthetic route and characterization of zinc selenide thin films},
	journal = {Journal of Physics and Chemistry of Solid},
	volume = {67},
	number = {11},
	year = {2006},
	month = {NOV},
	pages = {2310-2315},
	publisher = {PERGAMON-ELSEVIER SCIENCE LTD},
	type = {Article},
	address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, ENGLAND},
	abstract = {<p>Zinc selenide (ZnSe) thin film have been deposited using chemical bath method on non-conducting glass substrate in a tartarate bath containing zinc sulfate, ammonia, hydrazine hydrate, sodium selenosulfate in an aqueous alkaline medium at 333 K. The deposition parameter of the ZnSe thin film is interpreted in the present investigation. The films were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), optical absorption, electrical measurements, atomic absorption spectroscopy (AAS). The ZnSe thin layers grown with polycrystalline zinc blende system along with some amorphous phase present in ZnSe film. The direct optical band gap {\textquoteleft}E-g{\textquoteright} for the film was found to be 2.81 eV and electrical conductivity in the order of 10(-8)(Omega cm)(-1) with n-type conduction mechanism. (c) 2006 Elsevier Ltd. All rights reserved.</p>},
	keywords = {chalcogenides, electronic materials},
	issn = {0022-3697},
	doi = {10.1016/j.jpcs.2006.05.001},
	author = {Hankare, P. P. and Chate, P. A. and Delekar, S. D. and Asabe, M. R. and Mulla, Imtiaz S.}
}
@article { ISI:000246158300001,
	title = {Coprecipitation technique to prepare CoTa2O6 and CoNb2O6},
	journal = {Materials Letter},
	volume = {61},
	number = {11-12},
	year = {2007},
	month = {MAY},
	pages = {2127-2129},
	publisher = {ELSEVIER SCIENCE BV},
	type = {Article},
	address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS},
	abstract = {<p>An aqueous solution of sodium hydroxide was used to coprecipitate cobalt and tantalum (or niobium) ions from their precursors as hydroxides under basic conditions. This precipitate yielded CoTa2O6 (CT) or CoNb2O6 (CN) ceramics on calcining at 700 degrees C, i.e. at a temperature much lower than 900 degrees C, reported for the formation of these powders prepared by the traditional solid state method. The X-ray diffraction (XRD) studies were employed to investigate phase contents and lattice parameters. The morphology of the synthesized powders was investigated by transmission electron microscopy (TEM). (c) 2006 Elsevier B.V. All rights reserved.</p>},
	keywords = {Chemical synthesis, electronic materials, Oxides, X-ray methods},
	issn = {0167-577X},
	doi = {10.1016/j.matlet.2006.08.024},
	author = {Mulla, Imtiaz S. and Natarajan, N. and Gaikwad, A. B. and Samuel, V. and Guptha, U. N. and Ravi, V.}
}
