@article { ISI:000268022700058, title = {Magnetic and dielectric properties of nanophase manganese-substituted lithium ferrite}, journal = {Journal of Magnetism and Magnetic Materials}, volume = {321}, number = {19}, year = {2009}, month = {OCT}, pages = {3270-3273}, publisher = {ELSEVIER SCIENCE BV}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Nanocrystalline manganese-substituted lithium ferrites viz. Li0.5Fe2.5-xMnxO4 (2.5 \<= x \>= 0) were prepared by sol-gel autocombustion method. X-ray diffraction analysis confirmed that as the concentration of manganese increases the cubic phase changes to the tetragonal phase. The variation of saturation magnetization was studied as a function of manganese content. All the compositions indicate that they are ferrimagnetic in nature. The dielectric constant, dielectric loss tangent and ac conductivity of all samples were measured at room temperature as a function of frequency. These parameters decrease with increase in frequency for all of the samples. The substitution of manganese plays an important role in changing the structural and magnetic properties of these ferrites. The compositional variation of dielectric constant and d.c. resistivity shows an inverse trend of variation with each other. (C) 2009 Elsevier B.V. All rights reserved.

}, keywords = {dielectric constant, Ferrite, Magnetization, X-ray diffraction}, issn = {0304-8853}, doi = {10.1016/j.jmmm.2009.05.074}, author = {Hankare, P. P. and Patil, R. P. and Sankpal, U. B. and Jadhav, S. D. and Mulla, Imtiaz S. and Jadhav, K. M. and Chougule, B. K.} } @article { ISI:000272308600054, title = {Influence of palladium on gas-sensing performance of magnesium ferrite nanoparticles}, journal = {Materials Chemistry and Physics}, volume = {119}, number = {1-2}, year = {2010}, month = {JAN}, pages = {319-323}, publisher = {ELSEVIER SCIENCE SA}, address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND}, abstract = {

Commercial ferrites with high densities are mostly used in the electromagnetic devices, which require high temperature synthesis. In this article the gas-sensing characteristics of pure and Pd-doped MgFe(2)O(4) powder has been discussed. The synthesis has been carried out by using a simple molten salt method. This method facilitates rapid synthesis at comparatively lower temperature enabling formation of nanostructures, suitable for the gas-sensing application. Various physicochemical techniques have been used for the characterization of samples. X-ray diffraction analysis confirmed the single-phase formation of pure and Pd-doped MgFe(2)O(4) having crystallite size 15-20 nm. Pure MgFe(2)O(4) showed highest responses towards liquid petroleum gas (LPG) at 350 degrees C while, on doping with Pd the highest response shifted towards lower operating temperature of similar to 200 degrees C. Pure MgFe(2)O(4) exhibited some response towards 200 ppm of LPG which markedly increased on doping of palladium (Pd). The probable mechanism is proposed to explain the selective response towards LPG. (C) 2009 Elsevier B.V. All rights reserved.

}, keywords = {Doping, Ferrite, LPG sensor, Molten salt synthesis, Nanostructures}, issn = {0254-0584}, doi = {10.1016/j.matchemphys.2009.09.004}, author = {Darshane, Sonali L. and Mulla, Imtiaz S.} } @article { ISI:000318577600145, title = {Liquefied petroleum gas sensing performance of cerium doped copper ferrite}, journal = {Ceramics International}, volume = {39}, number = {5}, year = {2013}, month = {JUL}, pages = {5901-5907}, publisher = {ELSEVIER SCI LTD}, address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLAND}, abstract = {

Undoped and cerium (Ce) doped nanocrystalline copper ferrite (CuFe2O4) materials were synthesized via the molten-salt (M-S) method. Effects of Ce doping on the structural, morphological and gas sensing properties of the CuFe2O4 ferrite have been investigated. X-ray diffraction (XRD) analysis revealed the formation of spinel CuFe2O4. Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) investigations showed that the synthesized ferrite is made up of very fine spherical nanoparticles. Moreover, the gas sensing properties of sintered samples were studied towards different reducing gases such as liquefied petroleum gas (LPG), acetone, ethanol and ammonia. The sample with 4\% cerium doped CuFe2O4 (Ce4) showed the maximum gas sensitivity (86\%) towards LPG with fast response time of 5 s and good recovery time of 68 s. (C) 2013 Elsevier Ltd and Techna Group S.r.l. All rights reserved.

}, keywords = {Ferrite, Gas sensor, Molten-salt method, TEM}, issn = {0272-8842}, doi = {10.1016/j.ceramint.2013.01.010}, author = {Khandekar, M. S. and Tarwal, N. L. and Patil, J. Y. and Shaikh, F. I. and Mulla, Imtiaz S. and Suryavanshi, S. S.} } @article { ISI:000330820500057, title = {Nanocrystalline Ce doped CoFe2O4 as an acetone gas sensor}, journal = {Ceramics International}, volume = {40}, number = {1, A}, year = {2014}, month = {JAN}, pages = {447-452}, publisher = {ELSEVIER SCI LTD}, address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLAND}, abstract = {

Nanocrystalline CoFe2-xCexO4 ferrites (x=0, 0.04, 0.08) were synthesized by using the inexpensive, simple and eco-friendly molten-salt (M-S) method. Effects of Ce doping on the structural, morphological and gas sensing properties of the CoFe2O4 ferrite were investigated. X-ray diffraction (XRD) analysis revealed the formation of spinel CoFe2O4. Transmission electron microscopy (TEM) investigations showed that the synthesized ferrite is made up of very fine spherical nanoparticles. Furthermore, the gas response of nanocrystalline ferrite materials was investigated in the temperature range of 200-450 degrees C toward the reducing gases like liquefied petroleum gas (LPG), acetone, ethanol and ammonia. The sensor response was found to be sensitive and selective toward acetone as compared to other reducing gases. It is observed that the addition of Ce (4 wt\%) strongly influenced the response and the operating temperature of the sensor material and thus can serve as acetone-sensing sensors. (C) 2013 Elsevier Ltd and Techna Group S.r.l. All rights reserved.

}, keywords = {CoFe2O4, Ferrite, Gas sensor, Molten-salt method, TEM}, issn = {0272-8842}, doi = {10.1016/j.ceramint.2013.06.021}, author = {Khandekar, M. S. and Tarwal, N. L. and Mulla, Imtiaz S. and Suryavanshi, S. S.} }