@article { ISI:000255107700017,
	title = {EPR and DRS evidence for NO2 sensing in Al-doped ZnO},
	journal = {Sensors and Actuators B-Chemical},
	volume = {130},
	number = {2},
	year = {2008},
	month = {MAR},
	pages = {668-673},
	publisher = {ELSEVIER SCIENCE SA},
	type = {Article},
	address = {PO BOX 564, 1001 LAUSANNE, SWITZERLAND},
	abstract = {<p>Zinc oxide (ZnO) is a well-known semiconducting multifunctional material wherein properties right from the morphology to gas sensitivity can be tailor-made by doping or surface modification. Aluminum (Al)-incorporated porous zinc oxide (AI:ZnO) exhibits good response towards NO2 at low-operating temperature. The NO2 gas concentration as low as 20 ppm exhibits S = 17\% for 5 wt. \% Al-incorporated ZnO. The NO2 response increases with operating temperature and concentration and reaches to its maximum at 300 degrees C without any interference from other gases such as SO3, HCl, LPG and alcohol. Physico-chemical characterization likes differential thermogravimetric analysis (TG-DTA) electron paramagnetic resonance (EPR) and diffused reflectance spectroscopy (DRS) have been used to understand the sensing behavior for pure and A]-incorporated ZnO. The TG-DTA depicts formation of ZnO phase at 287 degrees C. The EPR study reveals distinct variation for O- (g=2.003) and Zn interstitial (g = 1.98) defect sites in pure and Al:ZnO. The DRS studies elucidate signature of adsorbed NO, species in aluminium-incorporated zinc oxide indicating its tendency to adsorb these species even at low temperatures. This paper is an attempt to correlate the gas sensing behavior with the physico-chemical studies such as EPR and DRS. (c) 2007 Published by Elsevier B.V.</p>},
	keywords = {aluminum doping, DRS, EPR, NO2 sensor, ZnO},
	issn = {0925-4005},
	doi = {10.1016/j.snb.2007.10.055},
	author = {Navale, Shalaka C. and Ravi, V. and Srinivas, D. and Mulla, Imtiaz S. and Gosavi, S. W. and Kulkarni, S. K.}
}
@article {45576,
	title = {Enhanced energy density and stability of self-assembled cauliflower of Pd doped monoclinic WO3 nanostructure supercapacitor},
	journal = {Materials Chemistry and Physics},
	volume = {225},
	year = {2019},
	month = {MAR},
	pages = {192-199},
	type = {Article},
	abstract = {Enhanced electrochemical performance of WO3 nanostructures by engineering their morphology, structural and surface defect at nanoscale is feasible. Herein we report the effect of Pd doping on the morphological and electrochemical properties of WO3 at nanoscale prepared by a simple hydrothermal method. The synthesized pristine WO3 (cabbage like morphology) and Pd doped WO3 (cauliflower like morphology) are examined by using XRD, XPS, Raman spectra, BET, FE-SEM, TEM. The morphological investigation shows the effective rebuilding of nanosheets assembled cabbage shaped pristine WO3 into nanobricks assembled cauliflower shaped Pd doped WO3 with improvement in crystallinity, surface area and conductivity. As a result, the enhancement in the electrochemical performance of cauliflower shaped Pd-WO3 is recorded four times higher specific capacitance than pristine WO3. Additionally, the excellent cyclic stability (almost ten times higher than pristine WO3) up to 1100 cycles with nearly 86.95\% capacity retention is observed in Pd-WO3 attributed to Pd content and highly modified structural arrangement.},
	doi = {10.1016/j.matchemphys.2018.12.077},
	author = {Gupta, S. P. and Patil, V. B. and Tarwal, N. L. and Bhame, S. D. and Gosavi, S. W. and Mulla, I. S. and Late, D. J. and Suryavanshi, S. S. and Walke, P. S.}
}
