@article {43686,
	title = {Synthesis of gamma-WO3 thin films by hot wire-CVD and investigation of its humidity sensing properties},
	journal = {Physica Status Solidi A-Applications and Materials Science},
	volume = {214},
	year = {2017},
	month = {MAY},
	pages = {Article Number: 1600717},
	type = {Article},
	abstract = {In this study, monoclinic tungsten oxide (gamma-WO3) have been grown in a single step using HW-CVD method by resistively heating W filaments in a constant O-2 pressure. The formation of gamma-WO3 was confirmed using low angle-XRD and Raman spectroscopy analysis. Low angle-XRD analysis revealed that as-deposited WO3 film are highly crystalline and the crystallites have preferred orientation along the (002) direction. HRTEM analysis and SAED pattern also show the highly crystalline nature of WO3 with d spacing of similar to 0.38 nm, having an orientation along the (002) direction. Surface topography investigated by SEM analysis shows the formation of a uniform and homogeneous cauliflower like morphology throughout the substrate surface without flaws and cracks. A humidity sensing device incorporating WO3 is also fabricated, which shows a maximum humidity sensitivity factor of similar to 3954\% along with a response time of similar to 14 s and a recovery time of similar to 25 s. The obtained results demonstrate that it is possible to synthesize WO3 in a single step by HW-CVD method and to fabricate a humidity sensor by using it. (C) 2017 WILEY-VCH Verlag GmbH \& Co. KGaA, Weinheim},
	doi = {10.1002/pssa.201600717},
	author = {Jadkar, Vijaya and Pawbake, Amit and Waykar, Ravindra and Jadhavar, Ashok and Date, Abhijit and Late, Dattatray and Pathan, Habib and Gosavi, Suresh and Jadkar, Sandesh}
}
@article {46097,
	title = {Solvothermal growth of PbBi2Se4 nano-flowers: a material for humidity sensor and photodetector applications},
	journal = {Physica Status Solidi A-Applications and Materials Science},
	volume = {216},
	year = {2019},
	month = {JUN},
	pages = {1900065},
	type = {Article},
	abstract = {<p>In the present work, lead bismuth selenide (PbBi2Se4) nano-flowers are synthesized by using a simple solvothermal method. Humidity sensor and photodetector based on PbBi2Se4 nano-flowers are fabricated on indium tin oxide (ITO) substrates and their sensing properties are investigated. Formation of PbBi2Se4 is confirmed by XRD, EDS, and XPS whereas formation of nano-flowers is confirmed by SEM and TEM analysis. XRD analysis reveals the hexagonal crystal structure of PbBi2Se4 phase with a = b = 4.22 angstrom, and c= 17.42 angstrom. The surface morphology of PbBi2Se4 clearly shows the formation of well-organized flower-like nanostructures which closely resembles the shape of Dahlia. The elemental mapping of chemical constituents obtained from SEM-EDS analysis shows uniform distribution of chemical constituents for the Pb, Bi, and Se in PbBi2Se4 nano-flowers. The PbBi2Se4 nano-flowers based humidity sensor has a typical response time of approximate to 65s and recovery time of approximate to 75 s. In case of PbBi2Se4 nano-flowers-based photodetector, the response and recovery time are observed approximate to 121 and approximate to 123 s, respectively, under visible light illumination with photoresponsivity (5 x 10(-6)), photosensitivity (2.16\%), and quantum efficiency (1.5 x 10(4)). The obtained results demonstrate the potential applications of solvothermally grown PbBi2Se4 nano-flowers-based devices for humidity sensors and photodetectors. The ease of the present work is to develop novel material to obtain device quality humidity sensors and photodetectors.</p>
},
	keywords = {humidity sensor, PbBi2Se4, photodetector, XPS, XRD},
	issn = {1862-6300},
	doi = {10.1002/pssa.201900065},
	author = {Aher, Rahul and Bhorde, Ajinkya and Nair, Shruthi and Borate, Haribhau and Pandharkar, Subhash and Naik, Dhirsing and Vairale, Priti and Karpe, Smita and Late, Dattatray and Prasad, Mohit and Jadkar, Sandesh}
}
