02460nas a2200253   4500008004100000022001400041245017300055210006900228260000900297300001600306490000600322520151900328653002801847653001801875653001401893653001901907653002501926100002101951700002701972700002301999700002502022700003002047856012902077       2021                        eng d  a2574-096200aAqueous methanol to formaldehyde and hydrogen on Pd/TiO2 by photocatalysis in direct sunlight: structure dependent activity of nano-Pd and atomic Pt-coated counterparts0 aAqueous methanol to formaldehyde and hydrogen on PdTiO2 by photo  cNOV   a13347-133600 v43 aIn the present investigation, facet-controlled Pd nanoparticles with nanocube (Pd-NC) and truncated octahedron (Pd-TO) morphologies, and their counterparts with half-a-monolayer of atomic Pt coated (0.5 theta(Pt)-Pd-NC and 0.5 theta(Pt)-Pd-TO) surfaces were prepared. All of them were characterized and evaluated as cocatalyst after supporting them on commercial titania (P25) (Pd-NC/P25, Pd-TO/P25, 0.5 theta(Pt)-Pd-NC/P25, and 0.5 theta(Pt)-Pd-TO/P25) under direct sunlight and/or one sun conditions for the oxidation of methanol to formaldehyde along with solar hydrogen production. Pd-NC/P25 shows higher activity for hydrogen generation compared to Pd-TO/P25; however, activity reversal occurs with the above cocatalysts, but, after Pt-coating with further enhanced activity. The highest conversion of methanol (0.2 mu mol/h.mg) to 100% selective formaldehyde was observed with 0.5 theta(Pt)-Pd-TO/P25, while other catalysts show significantly lower methanol conversion in the following order: 0.5 theta(Pt)-Pd-TO/P25 > 0.5 theta(Pt)-Pd-NC/P25 > Pd-NC/P25 > Pd-TO/P25. Pt-coated on (111) facets of Pd-TO simulates the activity associated as that of Pt(111) facets and demonstrating the highest and facet dependent activity. The present study is truly in resonance with exploiting the surface properties for heterogeneous catalysis, and highlights that less than a monolayer of Pt is sufficient to simulate the activity as that of bulk Pt. It is worth exploring this concept to other metals and substrates too.10aheterogeneous catalysis10aNanomaterials10aOxidation10aPhotocatalysis10asurface modification1 aNalajala, Naresh1 aSalgaonkar, Kranti, N.1 aChauhan, Inderjeet1 aMekala, Siva, Prasad1 aGopinath, Chinnakonda, S.  uhttp://library.ncl.res.in/content/aqueous-methanol-formaldehyde-and-hydrogen-pdtio2-photocatalysis-direct-sunlight-structure02916nas a2200229   4500008004100000022001400041245015400055210006900209260000900278300001600287490000700303520206700310100002702377700002102404700002302425700002102448700002302469700002002492700001802512700003002530856012602560       2023                        eng d  a2050-748800aBaby step in assembling and integrating the components of an artificial photosynthesis device with forced heterojunctions towards improved efficiency0 aBaby step in assembling and integrating the components of an art  cJUL   a15168-151820 v113 a<p>
	How to achieve unassisted, economical, scalable, and sustainable artificial photosynthesis for liquid fuels/products with improved solar-to-fuel efficiency (STFE) to address a carbon-neutral economy remains a big question. To a large degree, the extent of charge separation at heterojunction interfaces and charge utilization determine the STFE. Towards this, BiVO3 is assembled from ionic-precursors into TiO2 pores, and integrated structurally and electronically with TiO2 on calcination as BiVO4 quantum dots (BVQDs). BVQDs in TiO2 (BVT) pores lead to an all-inorganic system with a sub-quadrillion number of heterojunctions in a 1 cm(2) device (contains similar to 25 mu g of BiVO4 (similar to 2.5 wt%) in the nanopores of similar to 975 mu g of TiO2 (similar to 97.5 wt%)) and facilitate artificial photosynthesis. We demonstrate 31-38% STFE with a photon to chemical conversion turn over frequency (ToF(P2C)) of 2.73 s(-1) with a 1 cm(2) wireless BiVO4-TiO2 artificial leaf (BVT-AL) device for HCHO and CH3OH. The sequential nature of CO2 reduction to HCHO and then to CH3OH is evident from the reaction results. (CO2)-C-13 isotopic labeling experiments confirm that the input CO2 is the source for product formation. A large increase in the photocurrent density and incident photon-to-current efficiency (IPCE) of BVT, over 100% for the BiVO4 photoanode in visible light, demonstrates and supports efficient visible light absorption, charge separation and migration to the redox sites. A device has been demonstrated to show sustainable activity in direct sunlight, and addresses scalability from 1 to 9 cm(2). Assuming no change (50% decrease) in the STFE, a 6.74 m(2) device is expected to convert 1 (0.5) kg h(-1) CO2 into C1-oxygenates in sunlight. DFT calculations carried out with anatase TiO2 (101) and BiVO4 (121) interfaces support many of the experimental findings, including electron flow from the latter to the former, and interaction of the oxygen of TiO2 with BiVO4 and vice versa at the interface towards forced heterojunctions.</p>
1 aSalgaonkar, Kranti, N.1 aBajpai, Himanshu1 aMhamane, Nitin, B.1 aNalajala, Naresh1 aChauhan, Inderjeet1 aThakkar, Kavita1 aJoshi, Kavita1 aGopinath, Chinnakonda, S.  uhttp://library.ncl.res.in/content/baby-step-assembling-and-integrating-components-artificial-photosynthesis-device-forced02216nas a2200205   4500008004100000022001400041245012900055210006900184260000800253300001400261490000700275520145200282100002301734700002801757700002101785700002301806700002701829700003001856856012401886       2023                        eng d  a1477-922600aNanostructured Co-doped BiVO4 for efficient and sustainable photoelectrochemical chlorine evolution from simulated sea-water0 aNanostructured Codoped BiVO4 for efficient and sustainable photo  cFEB  a2051-20610 v523 a<p>
	The co-production of hydrogen and chlorine from sea-water splitting could be a potential, sustainable and attractive route by any method. However, challenges to overcome are many, and critically, the sustainability and operating potential of the electrocatalyst are important. In this work, we report on Co-doping in the BiVO4 (Co-BV) crystal lattice and employed the same as the photoanode; Co-BV exhibits a photocurrent of 190 mu A cm(-2) at 1.1 V vs. RHE (the reversible hydrogen electrode) in the acidic sodium chloride solution (pH 2.3) under one sun illumination. The best-performing photoanode, with 0.05 mol% of Co doping (0.05 Co-BV), selectively produced active chlorine with 92% faradaic efficiency at 1.1 V vs. RHE by successfully suppressing the kinetically sluggish oxygen evolution reaction (OER) and the stability of the catalyst was demonstrated for up to 20 h. This is the lowest operating potential reported for the chlorine evolution reaction (CER), thus far. The overpotential required for CER with 0.05 Co-BV is lower than that of OER, which leads to selective CER at 1.1 V (vs. RHE). Co-doping into the BiVO4 lattice decreases the charge transfer resistance and enhances the CER kinetics due to its structural and electronic integration with the BV lattice. We demonstrate that Co-doping also improves the lifetime of the charge carrier and enhances the current density of CER and sustainability of the catalyst.</p>
1 aChauhan, Inderjeet1 aPatra, Kshirodra, Kumar1 aBajpai, Himanshu1 aMhamane, Nitin, B.1 aSalgaonkar, Kranti, N.1 aGopinath, Chinnakonda, S.  uhttp://library.ncl.res.in/content/nanostructured-co-doped-bivo4-efficient-and-sustainable-photoelectrochemical-chlorine