@article { ISI:000227046400028, title = {Preparation and characterization of composite electrodes of coconut-shell-based activated carbon and hydrous ruthenium oxide for supercapacitors}, journal = {Journal of Power Sources}, volume = {141}, number = {1}, year = {2005}, month = {FEB}, pages = {198-203}, publisher = {ELSEVIER SCIENCE BV}, type = {Article}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

The relationship between the structure-specific capacitance (F g(-1)) of a composite electrode consisting of activated coconut-shell carbon and hydrous ruthenium oxide (RuOx(OH)(y)) has been evaluated by impregnating various amounts of RuOx(OH)(y) into activated carbon that is specially prepared with optimum pore-size distribution. The composite electrode shows an enhanced specific capacitance of 250 F g(-1) in 1 M H2SO4 with 9 wt.\% ruthenium incorporated. Chemical and structural characterization of the composites reveals a homogeneous distribution of amorphous RuOx(OH)(y) throughout the porous network of the activated carbon. Electrochemical characterization indicates an almost linear dependence of capacitance on the amount of ruthenium owing to its pseudocapacitive nature. (C) 2004 Elsevier B.V. All rights reserved.

}, keywords = {activated carbon, Composite, Electrochemical characterization, pseudocapacitance, specific capacitance, supercapacitor}, issn = {0378-7753}, doi = {10.1016/j.powsour.2004.09.008}, author = {Dandekar, M. S. and Arabale, G. and Vijayamohanan, K.} } @article {44014, title = {Influence of carbon based supports on selectivity behavior of diols and propanol in Ru catalyzed glycerol hydrogenolysis}, journal = {Applied Catalysis B: Environmental}, volume = {204}, year = {2017}, month = {MAY}, chapter = {134-146}, abstract = {

Activated carbon (AC) and three graphite materials were studied as supports for Ru catalyzed glycerol hydrogenolysis to propanediols and 1-propanol. Structural characteristics of AC and graphite materials were found to greatly affect the reducibility and particle size of supported Ru and hence, the activity and product distribution in glycerol hydrogenolysis. XRD of graphite materials showed distinctly (002) plane having highly organized layered structure and the peak intensity decreased in the order of Ru/KS150 \> Ru/HSAG100 \> Ru/KS6 due to decrease in the graphite sheet thickness. In Raman, the intense D band in HSAG100 compared to that in KS6 and KS150 samples indicated its highly amorphous nature or mixed carbon hybridization. Glycerol conversion for Ru on AC was higher than that on graphite and among different graphites, it showed a descending activity order of Ru/KS6 \> Ru/HSAG100 \> Ru/KS150. The product distribution for AC and HSAG100 supported Ru was similar, giving 1-propanol (45\%) alongwith 1,2-propanediol (1,2-PDO) (37\%) and 1,3-propanediol (1,3-PDO) (9{\textendash}11\%). For graphite supports, availability of Ru although bigger in size (4{\textendash}5 nm), would be higher on the surface than in case of AC which formed deep hydrogenolysis products like 1-, 2- propanol, ethanol etc.

}, keywords = {activated carbon, Amorphous carbon, catalysis, Glycerol, Glycerol conversions, Glycerol hydrogenolysis, graphite composites, Graphite supports, Hydrogenolysis, Hydrolysis, layered structures, Particle size, Product distributions, Propanediols, Propanol, Selectivity behavior, Structural characteristics, Structural effect, Structural effects}, issn = {0926-3373}, doi = {10.1016/j.apcatb.2016.11.032}, author = {Mane, Rasika B. and Patil, S. and Shirai, Masayuki and Rayalu, Sadhana S. and Rode, Chandrashekhar V.} } @article {44506, title = {Synthesis of biomass waste derived activated carbon-NBR composites for automobile application}, journal = {Chemistry and Chemical Technology}, volume = {12}, year = {2018}, pages = {236-243}, type = {Journal Article}, abstract = {

This paper reports on usability of activated carbon obtained from areca nut shell, coconut shell, and coconut leaves as a filler to prepare NBR based composite for automobile based application. The carbon was activated by phosphoric acid (H3PO4) as dehydrating agent. The stoichiometric ratio of biomass and phosphoric acid was found to be 3:1 for the batch size of 300 g. As compared to commercially available carbon filler, the activated carbon derived from biomass waste responded better to the petrol swelling test. Among three biomass waste sources, namely, areca nut shell, coconut shell, and coconut leaves, activated carbon derived from coconut shell was appeared to be the best for percent swelling and percent deviation in hardness. The results obtained are confirmed by proximate analysis.

}, keywords = {activated carbon, composites, hardness, NBR, Phosphoric acid}, issn = {19964196}, doi = {10.23939/chcht12.02.236}, author = {Jadhav, A. and Mohanraj, G.T. and Gokarn, A. and Mayadevi, S.} } @article {46355, title = {Ferets diameter estimation of activated carbon for effluent treatment application}, journal = {Journal of the Indian Chemical Society}, volume = {96}, year = {2019}, month = {AUG}, pages = {1067-1074}, type = {Article}, abstract = {

In this paper, activated carbon was produced of by chemical activation with phosphoric acid of agricultural wastes such as Arecanut shell of 25 micronmeter at 400 degrees C by slow pyrolysis. The BET surface area and iodine number surface area is calculated and compared. The FTIR spectra show the presence of activated carbon. The TGA revealed, activated carbon is thermally stable at 480 degrees C. The SEM shows the incorporation of activated carbon particles leads to the systematic change in morphology of activated carbon. Surface area plot shows the details of morphological change caused by iodine number surface area. Ferets diameter is estimated to know circularity of the particle. Methylene blue number, acid adsorption value is calculated to know adsorption capacity of the carbon. Thus results proves selection of ferets diameter, activation temperature, and impregnation ratio is important in determining the quality of activated carbon obtained and its use in industrial waste water treatment.

}, keywords = {activated carbon, Arecanut shell, Phosphoric acid, teret diameter}, issn = {0019-4522}, author = {Jadhav, Abhijit and Mohanraj, Govindraj and Gokarn, Ashok and Mayadevi, Susheeladevi} } @article {47372, title = {Synthesis of graphene from activated carbon at liquid nitrogen temperature and its detailed structural analysis}, journal = {Applied Physics A-Materials Science \& Processing}, volume = {127}, year = {2021}, month = {MAY}, pages = {319}, type = {Article}, abstract = {

The present study deals with the synthesis of graphene using thermal quenching of pre-heated activated carbon (a-C) (1370 K for 3 h) at liquid nitrogen temperature and its detailed structural analysis using XRD, TEM, FTIR and Raman spectroscopy. The analysis of lattice parameters (L-a, L-c,L- and d) of constituent nanographitic domains using XRD shows restoration of graphene-like structure in the resultant product (a-CL). TEM image reveals porosity and partially crystallinity (from SAED) in a-C. While thin layers of graphene are observed in the TEM images of a-CL Deconvoluted Raman spectra have been used to investigate the evolution of crystalline behaviour of a-C with temperature in view of Ferrari and Robertson{\textquoteright}s three-stage model. The evolution of G peak and increase in I-D/I-G reveals restoration of crystallinity in a-CL. The development of the D peak indicates disordering of graphite but ordering of amorphous carbon. The reported method is technologically beneficial for graphene synthesis for large number of applications such as supercapacitors, H-2 storage, gas separation and purification.

}, keywords = {activated carbon, Amorphous carbon, graphene, H-2 storage applications, Raman spectroscopy, Supercapacitors}, issn = {0947-8396}, doi = {10.1007/s00339-021-04416-w}, author = {Sharma, Preeti and Sharma, Geeta and Punia, Rajesh} } @article {46626, title = {Adsorption of toxic Pb(II) on activated carbon derived from agriculture waste (Mahogany fruit shell): isotherm, kinetic and thermodynamic study}, journal = {International Journal of Environmental Analytical Chemistry}, volume = {102}, year = {2022}, month = {DEC}, pages = {8270-8286}, type = {Article}, abstract = {

An adsorbent, mahogany fruit shell activated carbon(MFSAC), was derived from environmental friendly raw material, i.e. agriculture waste and explored for bench scale adsorption of toxic Pb(II). A facile MFSAC material was synthesised using a chemical activation method using concentrated sulphuric acid as an impregnating (activating) reagent. So derived adsorbent material was characterised by FTIR, XRD, BET, SEM, EDAX, TGA and XPS techniques to know the properties and plausible adsorption mechanism. Bench scale adsorption of toxic Pb(II) and maximum adsorption capacity of MFSAC were exhibited through batch adsorption experiments. The effect of physico-chemical parameters such as pH (1-7), MFSAC amount (0.5-5.0 g L-1), Pb(II) concentration (200-1000 mgL(-1)), contact period (60-600 min) and orbital shaking speed (60-200 rpm) was studied for maximum removal of Pb(II) upto 99.70 +/- 0.17\%. The experimental data follow the Langmuir adsorption isotherm with a maximum monolayer adsorption capacity 322.28 mg g(-1)and pseudo-second-order kinetic uptake rate. The thermodynamic and temperature study revealed that the adsorption process was spontaneous and endothermic in nature (Delta H-o = 43.37 kJ mole(-1), Delta S-o = 158.02 J mol(-1)K(-1)). Most importantly, the MFSAC adsorbent was successfully regenerated and reused with conspicuous performance up to five consecutive cycles. The bench-scale adsorption with simple synthesis route, good stability and remarkable regeneration capability makes the MFSAC as an encouraging adsorbent for wastewater treatment.

}, keywords = {activated carbon, Adsorption, mahogany fruit shell, Pb(II), sulphuric acid}, issn = {0306-7319}, doi = {10.1080/03067319.2020.1849648}, author = {Patil, Suryakant A. and Suryawanshi, Umesh P. and Harale, Namdev S. and Patil, Sandip K. and Vadiyar, Madgonda M. and Luwang, Meitram N. and Anuse, Mansing A. and Kim, Jin H. and Kolekar, Sanjay S.} }