@article { ISI:000344389000066, title = {Emulsion ionic liquid membranes (EILMs) for removal of Pb(II) from aqueous solutions}, journal = {RSC Advances}, volume = {4}, number = {94}, year = {2014}, month = {OCT}, pages = {52316-52323}, publisher = {ROYAL SOC CHEMISTRY}, address = {THOMAS GRAHAM HOUSE, SCIENCE PARK, MILTON RD, CAMBRIDGE CB4 0WF, CAMBS, ENGLAND}, abstract = {

Ionic liquids (ILs) are playing increasingly important roles in the membrane separation processes. The present manuscript discusses the removal of Pb(II) ions from aqueous solution using an emulsion ionic liquid membrane (EILM) process. Initially, the emulsion liquid membrane (ELM) was prepared by stirring strip phase (sulphuric acid) and organic phase (surfactant: span 80, extractant: D2EHPA, diluent: hexane) together under high speed agitation. Note that, the parameters of the ELM process such as emulsification speed, pH of the feed phase, treat ratio, extractant and surfactant concentrations were studied for the maximum removal of Pb(II) ions. The role of IL was explored by adding hydrophobic IL, octylmethylimidazole hexafluorophosphine ([OMIM][PF6]), in the organic phase. The performance of ELM with and without IL was compared on the basis of stability, enrichment factor and the removal efficiency for Pb(II). The results showed that the percentage of Pb(II) extraction was complete by the emulsion membrane with IL (EILM) in comparison to the 97\% achieved by neat ELM. Further, the stability and the enrichment factor of the EILM were found to be 2-3 times greater than that of the ELM. The FT-IR spectroscopic analysis revealed that bond interactions between IL and membrane phase components avoided the coalescence of internal phase droplets and enhanced the emulsion stability. The results obtained in this work support the use of the IL [OMIM][PF6] as both a stabilizer and carrier for the overall improvement of the ELM process.

}, issn = {2046-2069}, doi = {10.1039/c4ra06485b}, author = {Lende, Avinash B. and Dinker, Manish K. and Bhosale, Vikas K. and Kamble, Sanjay P. and Meshram, Pawan D. and Kulkarni, Prashant S.} } @article { ISI:000380417800044, title = {Efficacy of zero-valent copper (Cu-0) nanoparticles and reducing agents for dechlorination of mono chloroaromatics}, journal = {Chemosphere}, volume = {159}, year = {2016}, month = {SEP}, pages = {359-366}, publisher = {PERGAMON-ELSEVIER SCIENCE LTD}, address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, ENGLAND}, abstract = {

The zero-valent copper (Cu-0) nanoparticles were prepared by chemical reduction method. The morphology of nanoparticles was investigated by using X ray diffraction, scanning electron microscopy-energy dispersive X ray, UV-visible spectrophotometer and Brunauer-Emmett-Teller surface area analyser. The Cu-0 nanoparticles along with reducing agents, NaBH4/5\% acidified alcohol were used for the dechlorination of chloroaromatics at room temperature. Chlorobenzene (Cl-B), chlorotoluene (Cl-T), chloropyridine (Cl-Py) and chlorobiphenyl (Cl-BPh) were selected as the contaminants. The effect of various operating parameters such as pH, concentration of the catalyst and reducing agent (NaBH4), and recycling of the catalyst on dechlorination were studied. Nearly complete dechlorination of all the chloroaromatics were achieved in the presence of Cu-0 nanoparticles (2.5 g L-1) and NaBH4 (1.0 g L-1.) within 12 h. On the contrary, approximately 70\% of dechlorination was observed in the presence of 5\% acidified alcohol at similar experimental conditions. The dechlorination mechanism highlighted the importance of Cu-0 nanoparticles as a surface mediator. The kinetics of the dechlorination of chloroaromatics was investigated and compared with chloroaliphatics. The dechlorination rate differed from 0.23 h(-1) (Cl-B) to 0.15 h(-1) (Cl-BPh) in the presence of Cu-0 nanoparticles and NaBH4. The effectiveness of Cu nanoparticles with NaBH4 (1 g L-1) and 5\% acidified alcohol as electron donors were studied by oxidation-reduction potential and observed to be -1016 mV and -670 mV, respectively. Final products of the dechlorination were benzene, toluene, pyridine and biphenyl, as identified by gas chromatograph mass spectrometer and nuclear magnetic resonance spectroscopy. (C) 2016 Elsevier Ltd. All rights reserved.

}, keywords = {Acidified alcohol, ChloroAromatics, Hydrodechlorination, NaBH4, Wastewater treatment, Zero-valent copper (Cu-0) nanoparticles}, issn = {0045-6535}, doi = {10.1016/j.chemosphere.2016.06.031}, author = {Raut, Sandesh S. and Kamble, Sanjay P. and Kulkarni, Prashant S.} } @article {47983, title = {Enhanced anisole hydroxylation over a hierarchical micro/mesoporous TS-1 catalyst}, journal = {New Journal of Chemistry}, volume = {46}, year = {2022}, month = {AUG}, pages = {14667-14675}, type = {Article}, abstract = {

Hierarchical TS-1 materials were synthesized using hydrothermal synthesis and a post modification technique through desilication. They were evaluated for hydroxylation of anisole to produce industrially important chemicals, o-methoxyphenol (OMP) and p-methoxyphenol (PMP). The detailed characterization of the prepared catalysts, such as morphology, structure, nature of Ti and surface area were obtained by SEM, HR-TEM, XRD, UV-VIS spectroscopy and the BET technique. The effects of various operational parameters such as substrate/H2O2 molar ratio, reaction temperature, catalyst concentration and solvent effect on the hydroxylation of anisole have been studied in detail. The microporous TS-1 catalyst showed 32\% anisole conversion with 34\% selectivity to PMP, while the micro/mesoporous DTS-1 catalyst showed enhanced activity for anisole hydroxylation, i.e. 54\% conversion with 55\% selectivity towards PMP. The increased framework Ti and improved accessibility of the active sites located in the channels of DTS-1, which permit the mass transfer of reactants, transition states and products from the mesopores of DTS-1, were responsible for the enhanced catalytic activity and selectivity towards p-methoxyphenol.

}, issn = {1144-0546}, doi = {10.1039/d2nj01556k}, author = {Patil, Chetana R. and Niphadkar, Prashant and Kamble, Sanjay P. and Rode, V. Chandrashekhar} }