@article {47456, title = {Zinc-air batteries catalyzed using Co3O4 nanorod-supported N-doped entangled graphene for oxygen reduction reaction}, journal = {ACS Applied Energy Materials}, volume = {4}, year = {2021}, month = {MAY }, pages = {4570-4580}, type = {Article}, abstract = {

The work reported here deals with the development of an efficient non-platinum electrocatalyst for electrochemical oxygen reduction reaction (ORR) through a sequential pathway involving hydrothermal treatment followed by freeze-drying to build the desired structural architecture of the catalyst. The designed catalyst (Co3O4/nitrogen-doped entangled porous 3D graphene (NEGF)), which contains Co3O4 nanorods anchored on the surface of three-dimensional (3D)-structured N-doped graphene, was found to display higher ORR activity during single-electrode testing and demonstrate a Zn-air battery (ZAB) system. Under the hydrothermal treatment at 180 degrees C, in the presence of ammonia, nitrogen was doped into the carbon framework of graphene, which subsequently formed a self-assembled entangled 3D structure of graphene after freeze-drying. The hydrothermal treatment and freeze-drying processes were found to play vital roles in tuning the morphological and structural features of the catalyst. The doped nitrogen, apart from its favorable contribution toward ORR, helped facilitate efficient dispersion of oxide nanorods on graphene. Co3O4/NEGF displayed remarkable ORR activity in 0.1 M KOH solution, as evident from the 60 mV onset potential shift compared to the state-of-the-art Pt/C catalyst and the Tafel slope value of 74 mV dec(-1) vs 68 mV dec(-1) for Pt/C. The ZAB fabricated by employing Co3O4/NEGF as the cathode catalyst was found to be an efficient competitor for the system based on the Pt/C cathode. This high performance has been credited to the controlled interplay of the governing factors such as the interfacial interactions leading to the efficient dispersion of metal oxide nanorods, increased catalyst surface area, the cooperative effect arising from the defects present in the N-doped porous 3D graphene, and the synergetic interactions operating in the system.

}, keywords = {cobalt-oxide nanorod, freeze-drying, hydrothermal, N-doped entangled graphene, oxygen reduction reaction, zinc-air battery}, issn = {2574-0962}, doi = {10.1021/acsaem.1c00210}, author = {Manna, Narugopal and Singh, Santosh K. and Kharabe, Geeta Pandurang and Torris, Arun and Kurungot, Sreekumar} } @article {48201, title = {Pseudo-boehmite AlOOH supported NGr composite-based air electrode for mechanically rechargeable Zn-air battery applications}, journal = {Journal of Materials Chemistry A}, volume = {10}, year = {2022}, month = {MAY}, pages = {10014-10025}, type = {Article}, abstract = {

Both mechanically and electrically rechargeable zinc-air batteries (ZABs) have received much interest due to their high energy density and suitability for mobile and stationary applications. However, their commercialization has been impeded by the lack of robust, low-cost and environmentally benign catalyst materials that can be easily scaled up. In this context, the present work introduces a new type of transition metal-free catalytic material (AlOOH/NGr) by anchoring the pseudo-boehmite phase of aluminium oxyhydroxide (AlOOH) nanosheets over nitrogen-doped graphene (NGr) via a single-step and straightforward hydrothermal process. Furthermore, density functional theory (DFT) based computation demonstrates that the nucleation of AlOOH starts from the N-sites and points towards the strong surface interaction between AlOOH and NGr via doped nitrogen. AlOOH/NGr consisting of thin layered pseudo-boehmite sheets uniformly distributed over NGr has displayed an oxygen reduction reaction onset potential of 0.83 V and a half-wave potential of 0.72 V, along with good catalytic durability in alkaline medium. With this, AlOOH/NGr, when used as an air electrode for fabricating a primary Zn-air battery, the system has exhibited an open circuit voltage of similar to 1.27 V with a flat discharge profile at a current rate of 10 mA cm(-2). The fabricated system delivered a specific capacity of similar to 720 mA h g(-1) and a high power density of 204 mW cm(-2) and is comparable to the counterpart system based on the state-of-the-art Pt/C (20 wt\% Pt) cathode. Additionally, the homemade battery was able to maintain its performance after 4 times of mechanical recharging of the battery, which lasted for more than 35 h at a discharge current density of 10 mA cm(-2). Thus, we have uncovered the potential of an earth-abundant metal-based catalytic system for fabricating and demonstrating a robust mechanically rechargeable zinc-air battery.

}, issn = {2050-7488}, doi = {10.1039/d2ta00546h}, author = {Kharabe, Geeta Pandurang and Manna, Narugopal and Nadeema, Ayasha and Singh, Santosh K. and Mehta, Shweta and Nair, Aathira and Joshi, Kavita and Kurungot, Sreekumar} } @article {48309, title = {Cobalt-manganese modified theophrastite phase of nickel hydroxide nanoflower arrays on nickel foam as a self-standing bifunctional electrode for overall water electrolysis}, journal = {Sustainable Energy \& Fuels}, volume = {7}, year = {2023}, month = {MAY}, pages = {2428-2440}, type = {Article}, abstract = {

Designing and developing self-supported electrodes for water electrolysis is attractive as compared to conventional catalyst-coated electrodes. Herein, a (Co0.3Mn0.1Ni0.6)(OH)(2)/NF nanocomposite is prepared by anchoring (Co0.3Mn0.1Ni0.6)(OH)(2)via simple one-pot hydrothermal synthesis on nickel foam. The presence of Mn induces the external electronic structure of Co(OH)(2), and this also improves the electrochemically active surface area (ECSA). These favor better accessibility of active sites and increased intrinsic activity for the OER and HER. (Co0.3Mn0.1Ni0.6)(OH)(2)/NF has shown promising electrochemical activity toward the OER and HER in a 1 M KOH electrolyte, with an overpotential of 270 mV for the OER and 163 mV for the HER to deliver 10 mA cm(-2) current density. The overall water splitting was performed by employing (Co0.3Mn0.1Ni0.6)(OH)(2)/NF as both the cathode and anode by displaying a voltage of 1.62 V at 10 mA cm(-2), which is comparable to that extracted from a similar system based on the state-of-the-art Pt/C@NF cathode and RuO2@NF anode (1.60 V at 10 mA cm(-2)) standard electrode pair. Interestingly, at high current densities, the (Co0.3Mn0.1Ni0.6)(OH)(2)/NF//(Co0.3Mn0.1Ni0.6)(OH)(2)/NF system displayed better overall water splitting performance (1.78 V at 100 mA cm(-2)) compared to its Pt/C@NF//RuO2@NF (1.89 V at 100 mA cm(-2)) counterpart while displaying a stable output during the evolution period that lasted for 24 h. The amounts of H-2 and O-2 produced are estimated to be 701.2 and 358.6 mmol, respectively, at a time interval of 1 h; these amounts correspond to an similar to 1 : 2 ratio of O-2 and H-2, respectively. This study confirms the capability for employing (Co0.3Mn0.1Ni0.6)(OH)(2)/NF as a bi-functional and self-standing electrode for the realistic demonstrations of overall water splitting applications.

}, issn = {2398-4902}, doi = {10.1039/d3se00233k}, author = {Kharabe, Geeta Pandurang and Illathvalappil, Rajith and Barik, Sidharth and Kanheerampockil, Fayis and Walko, Priyanka S. and Bhat, Suresh K. and Devi, R. Nandini and Kurungot, Sreekumar} }