@article { ISI:000260230400034, title = {Scanning tunneling microscopic and field emission microscopic studies of nanostructured molybdenum film synthesized by electron cyclotron resonance plasma}, journal = {Vacuum}, volume = {83}, number = {2}, year = {2008}, month = {SEP}, pages = {435-443}, publisher = {PERGAMON-ELSEVIER SCIENCE LTD}, address = {THE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, ENGLAND}, abstract = {

Cathodic sputtering is demonstrated to be effective in synthesizing thin films of molybdenum nanoparticles. An electron cyclotron resonance plasma reactor has been used as the source. The particle size distribution is found to be controllable by proper choice of the cathodic bias potential. Sizes ranging between 20 and 30 nm deposited at the optimum bias potential are found to exhibit a self assembled structure as observed by scanning tunneling microscopy. Field emission microscopic studies on these films supported on W have exhibited very stable emission current over a period of 3 h. (C) 2008 Elsevier Ltd. All rights reserved.

}, keywords = {ECR plasma, Field emission microscopy, Hollow cathode chemical sputtering, Mo nanoparticles, Scanning tunneling microscopy}, issn = {0042-207X}, doi = {10.1016/j.vacuum.2008.04.077}, author = {Purohit, Vishwas S. and Bhise, Ashok B. and Dey, Shirshendu and More, Mahendra A. and Dharmadhikari, C. V. and Joag, Dilip S. and Pasricha, Renu and Bhoraskar, S. V.} } @article { ISI:000291725100012, title = {Synthesis of Cu-ZnO and C-ZnO nanoneedle arrays on zinc foil by low temperature oxidation route: effect of buffer layers on growth, optical and field emission properties}, journal = {Applied Surface Science}, volume = {257}, number = {20}, year = {2011}, month = {AUG}, pages = {8366-8372}, publisher = {ELSEVIER SCIENCE BV}, address = {PO BOX 211, 1000 AE AMSTERDAM, NETHERLANDS}, abstract = {

Different densities of ZnO nanoneedle films have been prepared by pre-coated zinc foils with thin layer of copper and carbon followed by thermal oxidation at 400 degrees C in air. The X-ray diffraction patterns show well defined peaks, which could be indexed to the wurtzite hexagonal phase of ZnO. The scanning electron microscope images clearly reveal formation of ZnO needles on the entire substrate surface. The X-ray photoelectron spectroscopy studies indicate that Cu and C ions are incorporated into the ZnO lattice. Photoluminescence studies evaluate different emission bands originated from different defect mechanism. From the field emission studies, the threshold field, required to draw emission current density of similar to 100 mu A/cm(2), is observed to be 2.25 V/mu m and 1.57 V/mu m for annealed zinc foil pre-coated with copper and carbon, respectively. The annealed film with copper layer exhibits good emission current stability at the pre-set value of similar to 100 mu A over a duration of 4 h. The results show that buffer layer is an important factor to control the growth rate, resulting in different density of ZnO needles, which leads to field emission properties. This method may have potential in fabrication of electron sources for high current density applications. (C) 2011 Elsevier B. V. All rights reserved.

}, keywords = {Buffer layer, Carbon, Copper, field emission, Nanoneedle, ZnO}, issn = {0169-4332}, doi = {10.1016/j.apsusc.2011.04.023}, author = {Jamali-Sheini, Farid and Patil, K. R. and Joag, Dilip S. and More, Mahendra A.} } @article { ISI:000288218300045, title = {Synthesis of single crystalline CdS nanocombs and their application in photo-sensitive field emission switches}, journal = {Nanoscale}, volume = {3}, number = {3}, year = {2011}, month = {JAN}, pages = {1078-1083}, publisher = {ROYAL SOC CHEMISTRY}, address = {THOMAS GRAHAM HOUSE, SCIENCE PARK, MILTON RD, CAMBRIDGE CB4 0WF, CAMBS, ENGLAND}, abstract = {

Single crystalline CdS nanocombs were synthesized by a thermal evaporation route. The photo-sensitive field emission current shows a reproducible switching behavior, with a rise in current level of nearly five times the initial preset value of similar to 1 mu A. An ultra low turn-on field, required to draw an emission current density of similar to 0.1 mu A cm(-2) (100 nA), is found to be similar to 0.26 V mu m(-1) (260 V), which is much lower than the reported values for various other CdS nanostructures. Upon illumination with visible light the CdS nanocombs act as a photo field emission switch. At an applied field of similar to 0.65 V mu m(-1) the current densities are observed to be similar to 14.6 mu A cm(-2) and similar to 26.9 mu A cm(-2), without and with light illumination, respectively. The average emission current is seen to be stable over the duration of measurement for two preset values. The high sensitivity and fast response in the visible range indicates that the CdS nanocombs can be used as a photo-sensitive field emitting switch in device applications, and also in pulsed electron beam technology.

}, issn = {2040-3364}, doi = {10.1039/c0nr00659a}, author = {Chavan, Padmakar G. and Badadhe, Satish S. and Mulla, Imtiaz S. and More, Mahendra A. and Joag, Dilip S.} } @article { ISI:000327521300003, title = {Superior field emission properties of layered WS2-RGO nanocomposites}, journal = {Scientific Reports}, volume = {3}, year = {2013}, month = {NOV}, pages = {3282}, publisher = {NATURE PUBLISHING GROUP}, address = {MACMILLAN BUILDING, 4 CRINAN ST, LONDON N1 9XW, ENGLAND}, abstract = {

We report here the field emission studies of a layered WS2-RGO composite at the base pressure of similar to 1 x 10(-8) mbar. The turn on field required to draw a field emission current density of 1 mu A/cm(2) is found to be 3.5, 2.3 and 2 V/mu m for WS2, RGO and the WS2-RGO composite respectively. The enhanced field emission behavior observed for the WS2-RGO nanocomposite is attributed to a high field enhancement factor of 2978, which is associated with the surface protrusions of the single-to-few layer thick sheets of the nanocomposite. The highest current density of similar to 800 mu A/cm(2) is drawn at an applied field of 4.1 V/mu m from a few layers of the WS2-RGO nanocomposite. Furthermore, first-principles density functional calculations suggest that the enhanced field emission may also be due to an overalp of the electronic structures of WS2 and RGO, where graphene-like states are dumped in the region of the WS2 fundamental gap.

}, issn = {2045-2322}, doi = {10.1038/srep03282}, author = {Rout, Chandra Sekhar and Joshi, Padmashree D. and Kashid, Ranjit V. and Joag, Dilip S. and More, Mahendra A. and Simbeck, Adam J. and Washington, Morris and Nayak, Saroj K. and Late, Dattatray J.} } @conference {45824, title = {Single SnO2 Nanowire: field emission investigations}, booktitle = {2016 29th International Vacuum Nanoelectronics Conference (IVNC)}, year = {2016}, month = {JUL}, publisher = {IEEE, 345 E 47th St, New York, NY 10017 USA}, organization = {IEEE, 345 E 47th St, New York, NY 10017 USA}, address = {345 E 47th St, New York, NY 10017 USA}, abstract = {

The present work deals with the field emission study on multiple SnO2 nanowires synthesized by simple thermal evaporation method. For the realistic analysis of the Fowler Nordheim plot of the semiconducting SnO2, field emission behavior of a single nanowire is studied. A relevant model explaining the field emission mechanism from the single SnO2 nanowire is also proposed by the authors.

}, keywords = {SnO2 nanowire}, isbn = {978-1-5090-2419-3}, author = {Joshi, D. and Joag, Dilip S. and Mulla, Imtiaz S. and Late, Dattatray J.} }